clocksource/drivers/orion: Read clock rate once
Rather than reading the clock rate three times, read it once - we are
about to add a fourth usage.
Signed-off-by: Russell King <rmk+kernel@armlinux.org.uk>
Signed-off-by: Daniel Lezcano <daniel.lezcano@linaro.org>
diff --git a/drivers/clocksource/time-orion.c b/drivers/clocksource/time-orion.c
index a28f496..c4818a5 100644
--- a/drivers/clocksource/time-orion.c
+++ b/drivers/clocksource/time-orion.c
@@ -106,6 +106,7 @@
static int __init orion_timer_init(struct device_node *np)
{
+ unsigned long rate;
struct clk *clk;
int irq, ret;
@@ -135,6 +136,8 @@
return -EINVAL;
}
+ rate = clk_get_rate(clk);
+
/* setup timer0 as free-running clocksource */
writel(~0, timer_base + TIMER0_VAL);
writel(~0, timer_base + TIMER0_RELOAD);
@@ -142,15 +145,15 @@
TIMER0_RELOAD_EN | TIMER0_EN,
TIMER0_RELOAD_EN | TIMER0_EN);
- ret = clocksource_mmio_init(timer_base + TIMER0_VAL, "orion_clocksource",
- clk_get_rate(clk), 300, 32,
+ ret = clocksource_mmio_init(timer_base + TIMER0_VAL,
+ "orion_clocksource", rate, 300, 32,
clocksource_mmio_readl_down);
if (ret) {
pr_err("Failed to initialize mmio timer");
return ret;
}
- sched_clock_register(orion_read_sched_clock, 32, clk_get_rate(clk));
+ sched_clock_register(orion_read_sched_clock, 32, rate);
/* setup timer1 as clockevent timer */
ret = setup_irq(irq, &orion_clkevt_irq);
@@ -162,7 +165,7 @@
ticks_per_jiffy = (clk_get_rate(clk) + HZ/2) / HZ;
orion_clkevt.cpumask = cpumask_of(0);
orion_clkevt.irq = irq;
- clockevents_config_and_register(&orion_clkevt, clk_get_rate(clk),
+ clockevents_config_and_register(&orion_clkevt, rate,
ORION_ONESHOT_MIN, ORION_ONESHOT_MAX);
return 0;