ixgb: convert to net_device_ops
Convert this driver to network device ops. Compile tested only.
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/ixgb/ixgb_main.c b/drivers/net/ixgb/ixgb_main.c
index cb7d1a6..3ca9daa 100644
--- a/drivers/net/ixgb/ixgb_main.c
+++ b/drivers/net/ixgb/ixgb_main.c
@@ -321,6 +321,23 @@
}
}
+static const struct net_device_ops ixgb_netdev_ops = {
+ .ndo_open = ixgb_open,
+ .ndo_stop = ixgb_close,
+ .ndo_get_stats = ixgb_get_stats,
+ .ndo_set_multicast_list = ixgb_set_multi,
+ .ndo_validate_addr = eth_validate_addr,
+ .ndo_set_mac_address = ixgb_set_mac,
+ .ndo_change_mtu = ixgb_change_mtu,
+ .ndo_tx_timeout = ixgb_tx_timeout,
+ .ndo_vlan_rx_register = ixgb_vlan_rx_register,
+ .ndo_vlan_rx_add_vid = ixgb_vlan_rx_add_vid,
+ .ndo_vlan_rx_kill_vid = ixgb_vlan_rx_kill_vid,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = ixgb_netpoll,
+#endif
+};
+
/**
* ixgb_probe - Device Initialization Routine
* @pdev: PCI device information struct
@@ -396,23 +413,11 @@
}
}
- netdev->open = &ixgb_open;
- netdev->stop = &ixgb_close;
+ netdev->netdev_ops = &ixgb_netdev_ops;
netdev->hard_start_xmit = &ixgb_xmit_frame;
- netdev->get_stats = &ixgb_get_stats;
- netdev->set_multicast_list = &ixgb_set_multi;
- netdev->set_mac_address = &ixgb_set_mac;
- netdev->change_mtu = &ixgb_change_mtu;
ixgb_set_ethtool_ops(netdev);
- netdev->tx_timeout = &ixgb_tx_timeout;
netdev->watchdog_timeo = 5 * HZ;
netif_napi_add(netdev, &adapter->napi, ixgb_clean, 64);
- netdev->vlan_rx_register = ixgb_vlan_rx_register;
- netdev->vlan_rx_add_vid = ixgb_vlan_rx_add_vid;
- netdev->vlan_rx_kill_vid = ixgb_vlan_rx_kill_vid;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- netdev->poll_controller = ixgb_netpoll;
-#endif
strncpy(netdev->name, pci_name(pdev), sizeof(netdev->name) - 1);