mmc: Fixes for Dual Data Rate (DDR) support
The DDR support patch needs the following fixes:
- The block driver does not need to know about DDR, any more
than it needs to know about bus width.
- Not only the card must be switched to DDR mode. The host
controller must also be configured, which is done through
the 'set_ios()' function.
- Do not set the DDR mode state until after the switch command
is successful.
- Setting block length is not supported in DDR mode. Make that
a core function and change the other place it is used (mmc_test)
also.
Signed-off-by: Adrian Hunter <adrian.hunter@nokia.com>
Signed-off-by: Chris Ball <cjb@laptop.org>
diff --git a/include/linux/mmc/host.h b/include/linux/mmc/host.h
index 6711eb8..c4fb1c5 100644
--- a/include/linux/mmc/host.h
+++ b/include/linux/mmc/host.h
@@ -50,6 +50,11 @@
#define MMC_TIMING_LEGACY 0
#define MMC_TIMING_MMC_HS 1
#define MMC_TIMING_SD_HS 2
+
+ unsigned char ddr; /* dual data rate used */
+
+#define MMC_SDR_MODE 0
+#define MMC_DDR_MODE 1
};
struct mmc_host_ops {