Bluetooth: Add initial sleep support to Three-wire UART
This patch adds very basic support for the sleep related messages. The
only thing the code does right now is send a wakeup message as soon as
receiving a sleep one, essentially preventing the controller from going
to sleep.
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Signed-off-by: Gustavo Padovan <gustavo.padovan@collabora.co.uk>
diff --git a/drivers/bluetooth/hci_h5.c b/drivers/bluetooth/hci_h5.c
index eb40b9a..d9d42f6 100644
--- a/drivers/bluetooth/hci_h5.c
+++ b/drivers/bluetooth/hci_h5.c
@@ -74,6 +74,8 @@
bool tx_ack_req; /* Pending ack to send */
u8 tx_seq; /* Next seq number to send */
u8 tx_ack; /* Next ack number to send */
+
+ bool sleeping;
};
static void h5_reset_rx(struct h5 *h5);
@@ -211,6 +213,9 @@
const unsigned char sync_rsp[] = { 0x02, 0x7d };
const unsigned char conf_req[] = { 0x03, 0xfc, 0x01 };
const unsigned char conf_rsp[] = { 0x04, 0x7b, 0x01 };
+ const unsigned char wakeup_req[] = { 0x05, 0xfa };
+ const unsigned char woken_req[] = { 0x06, 0xf9 };
+ const unsigned char sleep_req[] = { 0x07, 0x78 };
const unsigned char *hdr = h5->rx_skb->data;
const unsigned char *data = &h5->rx_skb->data[4];
@@ -233,6 +238,14 @@
BT_DBG("Three-wire init sequence complete");
hci_uart_init_ready(hu);
return;
+ } else if (memcmp(data, sleep_req, 2) == 0) {
+ BT_DBG("Peer went to sleep");
+ h5->sleeping = true;
+ h5_link_control(hu, wakeup_req, 2);
+ } else if (memcmp(data, woken_req, 2) == 0) {
+ BT_DBG("Peer woke up");
+ h5->sleeping = false;
+ return;
} else {
BT_DBG("Link Control: 0x%02hhx 0x%02hhx", data[0], data[1]);
return;