iwlwifi: give trans to all the read / write functions
From now on, the transport layer in charge of providing access to the
device. So change all the driver to give a pointer to the transport
to all the low level functions that actually access the device.
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-1000.c b/drivers/net/wireless/iwlwifi/iwl-1000.c
index cc04cce..f7a555b 100644
--- a/drivers/net/wireless/iwlwifi/iwl-1000.c
+++ b/drivers/net/wireless/iwlwifi/iwl-1000.c
@@ -84,13 +84,13 @@
static void iwl1000_nic_config(struct iwl_priv *priv)
{
/* set CSR_HW_CONFIG_REG for uCode use */
- iwl_set_bit(bus(priv), CSR_HW_IF_CONFIG_REG,
+ iwl_set_bit(trans(priv), CSR_HW_IF_CONFIG_REG,
CSR_HW_IF_CONFIG_REG_BIT_RADIO_SI |
CSR_HW_IF_CONFIG_REG_BIT_MAC_SI);
/* Setting digital SVR for 1000 card to 1.32V */
/* locking is acquired in iwl_set_bits_mask_prph() function */
- iwl_set_bits_mask_prph(bus(priv), APMG_DIGITAL_SVR_REG,
+ iwl_set_bits_mask_prph(trans(priv), APMG_DIGITAL_SVR_REG,
APMG_SVR_DIGITAL_VOLTAGE_1_32,
~APMG_SVR_VOLTAGE_CONFIG_BIT_MSK);
}