Bluetooth: Parameters for outgoing SCO connections
In order to establish a transparent SCO connection, the correct settings
must be specified in the Setup Synchronous Connection request. For that,
a setting field is added to ACL connection data to set up the desired
parameters. The patch also removes usage of hdev->voice_setting in CVSD
connection and makes use of T2 parameters for transparent data.
Signed-off-by: Frédéric Dalleau <frederic.dalleau@linux.intel.com>
Signed-off-by: Johan Hedberg <johan.hedberg@intel.com>
Acked-by: Marcel Holtmann <marcel@holtmann.org>
Signed-off-by: Gustavo Padovan <gustavo.padovan@collabora.co.uk>
diff --git a/net/bluetooth/hci_conn.c b/net/bluetooth/hci_conn.c
index 5f1f448..c0e56a5 100644
--- a/net/bluetooth/hci_conn.c
+++ b/net/bluetooth/hci_conn.c
@@ -185,13 +185,24 @@
conn->attempt++;
cp.handle = cpu_to_le16(handle);
- cp.pkt_type = cpu_to_le16(conn->pkt_type);
cp.tx_bandwidth = __constant_cpu_to_le32(0x00001f40);
cp.rx_bandwidth = __constant_cpu_to_le32(0x00001f40);
- cp.max_latency = __constant_cpu_to_le16(0xffff);
- cp.voice_setting = cpu_to_le16(hdev->voice_setting);
- cp.retrans_effort = 0xff;
+ cp.voice_setting = cpu_to_le16(conn->setting);
+
+ switch (conn->setting & SCO_AIRMODE_MASK) {
+ case SCO_AIRMODE_TRANSP:
+ cp.pkt_type = __constant_cpu_to_le16(EDR_ESCO_MASK &
+ ~ESCO_2EV3);
+ cp.max_latency = __constant_cpu_to_le16(0x000d);
+ cp.retrans_effort = 0x02;
+ break;
+ case SCO_AIRMODE_CVSD:
+ cp.pkt_type = cpu_to_le16(conn->pkt_type);
+ cp.max_latency = __constant_cpu_to_le16(0xffff);
+ cp.retrans_effort = 0xff;
+ break;
+ }
hci_send_cmd(hdev, HCI_OP_SETUP_SYNC_CONN, sizeof(cp), &cp);
}
@@ -560,7 +571,8 @@
return acl;
}
-struct hci_conn *hci_connect_sco(struct hci_dev *hdev, int type, bdaddr_t *dst)
+struct hci_conn *hci_connect_sco(struct hci_dev *hdev, int type, bdaddr_t *dst,
+ __u16 setting)
{
struct hci_conn *acl;
struct hci_conn *sco;
@@ -583,6 +595,8 @@
hci_conn_hold(sco);
+ sco->setting = setting;
+
if (acl->state == BT_CONNECTED &&
(sco->state == BT_OPEN || sco->state == BT_CLOSED)) {
set_bit(HCI_CONN_POWER_SAVE, &acl->flags);