spi: s3c64xx: do not configure the device twice
At the start of the transfer, the spi_config function is called
twice, the first time when the 3c64xx_spi_prepare_message is
called and the second time with the s3c64xx_spi_transfer_one,
both called from the spi framework.
Remove the first call at the prepare message because in that
point we don't have the imformation about "bit per word" and
frequency.
Signed-off-by: Andi Shyti <andi.shyti@samsung.com>
Signed-off-by: Mark Brown <broonie@kernel.org>
diff --git a/drivers/spi/spi-s3c64xx.c b/drivers/spi/spi-s3c64xx.c
index 14269b0..c65a9e6 100644
--- a/drivers/spi/spi-s3c64xx.c
+++ b/drivers/spi/spi-s3c64xx.c
@@ -676,16 +676,6 @@
struct spi_device *spi = msg->spi;
struct s3c64xx_spi_csinfo *cs = spi->controller_data;
- /* If Master's(controller) state differs from that needed by Slave */
- if (sdd->cur_speed != spi->max_speed_hz
- || sdd->cur_mode != spi->mode
- || sdd->cur_bpw != spi->bits_per_word) {
- sdd->cur_bpw = spi->bits_per_word;
- sdd->cur_speed = spi->max_speed_hz;
- sdd->cur_mode = spi->mode;
- s3c64xx_spi_config(sdd);
- }
-
/* Configure feedback delay */
writel(cs->fb_delay & 0x3, sdd->regs + S3C64XX_SPI_FB_CLK);
@@ -712,6 +702,7 @@
if (bpw != sdd->cur_bpw || speed != sdd->cur_speed) {
sdd->cur_bpw = bpw;
sdd->cur_speed = speed;
+ sdd->cur_mode = spi->mode;
s3c64xx_spi_config(sdd);
}