KVM: PPC: Remove PPC970 from KVM_BOOK3S_64_HV text in Kconfig
Since the PPC970 support has been removed from the kvm-hv kernel
module recently, we should also reflect this change in the help
text of the corresponding Kconfig option.
Signed-off-by: Thomas Huth <thuth@redhat.com>
Signed-off-by: Alexander Graf <agraf@suse.de>
diff --git a/arch/powerpc/kvm/Kconfig b/arch/powerpc/kvm/Kconfig
index 3caec2c..c2024ac 100644
--- a/arch/powerpc/kvm/Kconfig
+++ b/arch/powerpc/kvm/Kconfig
@@ -74,14 +74,14 @@
If unsure, say N.
config KVM_BOOK3S_64_HV
- tristate "KVM support for POWER7 and PPC970 using hypervisor mode in host"
+ tristate "KVM for POWER7 and later using hypervisor mode in host"
depends on KVM_BOOK3S_64 && PPC_POWERNV
select KVM_BOOK3S_HV_POSSIBLE
select MMU_NOTIFIER
select CMA
---help---
Support running unmodified book3s_64 guest kernels in
- virtual machines on POWER7 and PPC970 processors that have
+ virtual machines on POWER7 and newer processors that have
hypervisor mode available to the host.
If you say Y here, KVM will use the hardware virtualization
@@ -89,8 +89,8 @@
guest operating systems will run at full hardware speed
using supervisor and user modes. However, this also means
that KVM is not usable under PowerVM (pHyp), is only usable
- on POWER7 (or later) processors and PPC970-family processors,
- and cannot emulate a different processor from the host processor.
+ on POWER7 or later processors, and cannot emulate a
+ different processor from the host processor.
If unsure, say N.