usb: misc: EHSET Test Fixture device driver for host compliance
An Embedded Host High-Speed Electrical Test (EHSET) test fixture is
used to initiate test modes on a host controller in order to perform
the high speed electrical testing procedure for USB-IF compliance.
When this test fixture is connected to a host, it can enumerate as
one of several selectable VID/PID pairs, each corresponding to one
of the following test modes:
* TEST_SE0_NAK
* TEST_J
* TEST_K
* TEST_PACKET
* HS_HOST_PORT_SUSPEND_RESUME
* SINGLE_STEP_GET_DEV_DESC
* SINGLE_STEP_SET_FEATURE
The USB EHSET procedure can be found here:
http://www.usb.org/developers/onthego/EHSET_v1.01.pdf
Signed-off-by: Manu Gautam <mgautam@codeaurora.org>
[jackp@codeaurora.org: imported from commit 073c9409 on codeaurora.org;
minor cleanup and updated author email]
Signed-off-by: Jack Pham <jackp@codeaurora.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/usb/misc/Kconfig b/drivers/usb/misc/Kconfig
index a51e7d6..ca91420 100644
--- a/drivers/usb/misc/Kconfig
+++ b/drivers/usb/misc/Kconfig
@@ -200,6 +200,19 @@
See <http://www.linux-usb.org/usbtest/> for more information,
including sample test device firmware and "how to use it".
+config USB_EHSET_TEST_FIXTURE
+ tristate "USB EHSET Test Fixture driver"
+ help
+ Say Y here if you want to support the special test fixture device
+ used for the USB-IF Embedded Host High-Speed Electrical Test procedure.
+
+ When the test fixture is connected, it can enumerate as one of several
+ VID/PID pairs. This driver then initiates a corresponding test mode on
+ the downstream port to which the test fixture is attached.
+
+ See <http://www.usb.org/developers/onthego/EHSET_v1.01.pdf> for more
+ information.
+
config USB_ISIGHTFW
tristate "iSight firmware loading support"
select FW_LOADER