mtd: add GPMI-NAND driver in the config and Makefile
add the GPMI-NAND driver in the relevant Kconfig and Makefile in the MTD.
Signed-off-by: Huang Shijie <b32955@freescale.com>
Acked-by: Marek Vasut <marek.vasut@gmail.com>
Tested-by: Koen Beel <koen.beel@barco.com>
Signed-off-by: Artem Bityutskiy <artem.bityutskiy@intel.com>
diff --git a/drivers/mtd/nand/Kconfig b/drivers/mtd/nand/Kconfig
index 7ec5b49..42b7b86 100644
--- a/drivers/mtd/nand/Kconfig
+++ b/drivers/mtd/nand/Kconfig
@@ -417,6 +417,19 @@
The simulator may simulate various NAND flash chips for the
MTD nand layer.
+config MTD_NAND_GPMI_NAND
+ bool "GPMI NAND Flash Controller driver"
+ depends on MTD_NAND && (SOC_IMX23 || SOC_IMX28)
+ select MTD_PARTITIONS
+ select MTD_CMDLINE_PARTS
+ help
+ Enables NAND Flash support for IMX23 or IMX28.
+ The GPMI controller is very powerful, with the help of BCH
+ module, it can do the hardware ECC. The GPMI supports several
+ NAND flashs at the same time. The GPMI may conflicts with other
+ block, such as SD card. So pay attention to it when you enable
+ the GPMI.
+
config MTD_NAND_PLATFORM
tristate "Support for generic platform NAND driver"
help