netdev: convert cs89x0 to net_device_ops
Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/cs89x0.c b/drivers/net/cs89x0.c
index ff64976..7433b88 100644
--- a/drivers/net/cs89x0.c
+++ b/drivers/net/cs89x0.c
@@ -501,6 +501,21 @@
}
#endif
+static const struct net_device_ops net_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_tx_timeout = net_timeout,
+ .ndo_start_xmit = net_send_packet,
+ .ndo_get_stats = net_get_stats,
+ .ndo_set_multicast_list = set_multicast_list,
+ .ndo_set_mac_address = set_mac_address,
+#ifdef CONFIG_NET_POLL_CONTROLLER
+ .ndo_poll_controller = net_poll_controller,
+#endif
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
/* This is the real probe routine. Linux has a history of friendly device
probes on the ISA bus. A good device probes avoids doing writes, and
verifies that the correct device exists and functions.
@@ -843,17 +858,8 @@
/* print the ethernet address. */
printk(", MAC %pM", dev->dev_addr);
- dev->open = net_open;
- dev->stop = net_close;
- dev->tx_timeout = net_timeout;
- dev->watchdog_timeo = HZ;
- dev->hard_start_xmit = net_send_packet;
- dev->get_stats = net_get_stats;
- dev->set_multicast_list = set_multicast_list;
- dev->set_mac_address = set_mac_address;
-#ifdef CONFIG_NET_POLL_CONTROLLER
- dev->poll_controller = net_poll_controller;
-#endif
+ dev->netdev_ops = &net_ops;
+ dev->watchdog_timeo = HZ;
printk("\n");
if (net_debug)