ARM: dts: Leave sdio1 as disabled on bcm28155-ap
The sdio1 interface pins are routed to an unpopulated daughter card
connector on the bcm28155-ap board. Thus there is no need to mark
this interface as enabled.
Signed-off-by: Tim Kryger <tim.kryger@linaro.org>
Reviewed-by: Matt Porter <mporter@linaro.org>
Signed-off-by: Matt Porter <mporter@linaro.org>
diff --git a/arch/arm/boot/dts/bcm28155-ap.dts b/arch/arm/boot/dts/bcm28155-ap.dts
index 5ff2382..3604554 100644
--- a/arch/arm/boot/dts/bcm28155-ap.dts
+++ b/arch/arm/boot/dts/bcm28155-ap.dts
@@ -49,11 +49,6 @@
clock-frequency = <400000>;
};
- sdio1: sdio@3f180000 {
- max-frequency = <48000000>;
- status = "okay";
- };
-
sdio2: sdio@3f190000 {
non-removable;
max-frequency = <48000000>;