blob: 50b9aad5e27b729acc2aa060be4d604d866ef07b [file] [log] [blame]
/* linux/arch/arm/mach-exynos4/platsmp.c
*
* Copyright (c) 2010-2011 Samsung Electronics Co., Ltd.
* http://www.samsung.com
*
* Cloned from linux/arch/arm/mach-vexpress/platsmp.c
*
* Copyright (C) 2002 ARM Ltd.
* All Rights Reserved
*
* This program is free software; you can redistribute it and/or modify
* it under the terms of the GNU General Public License version 2 as
* published by the Free Software Foundation.
*/
#include <linux/init.h>
#include <linux/errno.h>
#include <linux/delay.h>
#include <linux/device.h>
#include <linux/jiffies.h>
#include <linux/smp.h>
#include <linux/io.h>
#include <linux/of_address.h>
#include <asm/cacheflush.h>
#include <asm/smp_plat.h>
#include <asm/smp_scu.h>
#include <asm/firmware.h>
#include "common.h"
#include "regs-pmu.h"
extern void exynos4_secondary_startup(void);
static inline void __iomem *cpu_boot_reg_base(void)
{
if (soc_is_exynos4210() && samsung_rev() == EXYNOS4210_REV_1_1)
return S5P_INFORM5;
return sysram_base_addr;
}
static inline void __iomem *cpu_boot_reg(int cpu)
{
void __iomem *boot_reg;
boot_reg = cpu_boot_reg_base();
if (!boot_reg)
return ERR_PTR(-ENODEV);
if (soc_is_exynos4412())
boot_reg += 4*cpu;
else if (soc_is_exynos5420() || soc_is_exynos5800())
boot_reg += 4;
return boot_reg;
}
/*
* Write pen_release in a way that is guaranteed to be visible to all
* observers, irrespective of whether they're taking part in coherency
* or not. This is necessary for the hotplug code to work reliably.
*/
static void write_pen_release(int val)
{
pen_release = val;
smp_wmb();
sync_cache_w(&pen_release);
}
static void __iomem *scu_base_addr(void)
{
return (void __iomem *)(S5P_VA_SCU);
}
static DEFINE_SPINLOCK(boot_lock);
static void exynos_secondary_init(unsigned int cpu)
{
/*
* let the primary processor know we're out of the
* pen, then head off into the C entry point
*/
write_pen_release(-1);
/*
* Synchronise with the boot thread.
*/
spin_lock(&boot_lock);
spin_unlock(&boot_lock);
}
static int exynos_boot_secondary(unsigned int cpu, struct task_struct *idle)
{
unsigned long timeout;
u32 mpidr = cpu_logical_map(cpu);
u32 core_id = MPIDR_AFFINITY_LEVEL(mpidr, 0);
int ret = -ENOSYS;
/*
* Set synchronisation state between this boot processor
* and the secondary one
*/
spin_lock(&boot_lock);
/*
* The secondary processor is waiting to be released from
* the holding pen - release it, then wait for it to flag
* that it has been released by resetting pen_release.
*
* Note that "pen_release" is the hardware CPU core ID, whereas
* "cpu" is Linux's internal ID.
*/
write_pen_release(core_id);
if (!exynos_cpu_power_state(core_id)) {
exynos_cpu_power_up(core_id);
timeout = 10;
/* wait max 10 ms until cpu1 is on */
while (exynos_cpu_power_state(core_id)
!= S5P_CORE_LOCAL_PWR_EN) {
if (timeout-- == 0)
break;
mdelay(1);
}
if (timeout == 0) {
printk(KERN_ERR "cpu1 power enable failed");
spin_unlock(&boot_lock);
return -ETIMEDOUT;
}
}
/*
* Send the secondary CPU a soft interrupt, thereby causing
* the boot monitor to read the system wide flags register,
* and branch to the address found there.
*/
timeout = jiffies + (1 * HZ);
while (time_before(jiffies, timeout)) {
unsigned long boot_addr;
smp_rmb();
boot_addr = virt_to_phys(exynos4_secondary_startup);
/*
* Try to set boot address using firmware first
* and fall back to boot register if it fails.
*/
ret = call_firmware_op(set_cpu_boot_addr, core_id, boot_addr);
if (ret && ret != -ENOSYS)
goto fail;
if (ret == -ENOSYS) {
void __iomem *boot_reg = cpu_boot_reg(core_id);
if (IS_ERR(boot_reg)) {
ret = PTR_ERR(boot_reg);
goto fail;
}
__raw_writel(boot_addr, cpu_boot_reg(core_id));
}
call_firmware_op(cpu_boot, core_id);
arch_send_wakeup_ipi_mask(cpumask_of(cpu));
if (pen_release == -1)
break;
udelay(10);
}
/*
* now the secondary core is starting up let it run its
* calibrations, then wait for it to finish
*/
fail:
spin_unlock(&boot_lock);
return pen_release != -1 ? ret : 0;
}
/*
* Initialise the CPU possible map early - this describes the CPUs
* which may be present or become present in the system.
*/
static void __init exynos_smp_init_cpus(void)
{
void __iomem *scu_base = scu_base_addr();
unsigned int i, ncores;
if (read_cpuid_part_number() == ARM_CPU_PART_CORTEX_A9)
ncores = scu_base ? scu_get_core_count(scu_base) : 1;
else
/*
* CPU Nodes are passed thru DT and set_cpu_possible
* is set by "arm_dt_init_cpu_maps".
*/
return;
/* sanity check */
if (ncores > nr_cpu_ids) {
pr_warn("SMP: %u cores greater than maximum (%u), clipping\n",
ncores, nr_cpu_ids);
ncores = nr_cpu_ids;
}
for (i = 0; i < ncores; i++)
set_cpu_possible(i, true);
}
static void __init exynos_smp_prepare_cpus(unsigned int max_cpus)
{
int i;
exynos_sysram_init();
if (read_cpuid_part_number() == ARM_CPU_PART_CORTEX_A9)
scu_enable(scu_base_addr());
/*
* Write the address of secondary startup into the
* system-wide flags register. The boot monitor waits
* until it receives a soft interrupt, and then the
* secondary CPU branches to this address.
*
* Try using firmware operation first and fall back to
* boot register if it fails.
*/
for (i = 1; i < max_cpus; ++i) {
unsigned long boot_addr;
u32 mpidr;
u32 core_id;
int ret;
mpidr = cpu_logical_map(i);
core_id = MPIDR_AFFINITY_LEVEL(mpidr, 0);
boot_addr = virt_to_phys(exynos4_secondary_startup);
ret = call_firmware_op(set_cpu_boot_addr, core_id, boot_addr);
if (ret && ret != -ENOSYS)
break;
if (ret == -ENOSYS) {
void __iomem *boot_reg = cpu_boot_reg(core_id);
if (IS_ERR(boot_reg))
break;
__raw_writel(boot_addr, cpu_boot_reg(core_id));
}
}
}
struct smp_operations exynos_smp_ops __initdata = {
.smp_init_cpus = exynos_smp_init_cpus,
.smp_prepare_cpus = exynos_smp_prepare_cpus,
.smp_secondary_init = exynos_secondary_init,
.smp_boot_secondary = exynos_boot_secondary,
#ifdef CONFIG_HOTPLUG_CPU
.cpu_die = exynos_cpu_die,
#endif
};