Add TI CDCE925 I2C controlled clock synthesizer driver
This driver supports the TI CDCE925 programmable clock synthesizer.
The chip contains two PLLs with spread-spectrum clocking support and
five output dividers. The driver only supports the following setup,
and uses a fixed setting for the output muxes:
Y1 is derived from the input clock
Y2 and Y3 derive from PLL1
Y4 and Y5 derive from PLL2
Given a target output frequency, the driver will set the PLL and
divider to best approximate the desired output.
Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Signed-off-by: Michael Turquette <mturquette@linaro.org>
diff --git a/drivers/clk/Makefile b/drivers/clk/Makefile
index d965b3f..00ae2de 100644
--- a/drivers/clk/Makefile
+++ b/drivers/clk/Makefile
@@ -38,6 +38,7 @@
obj-$(CONFIG_COMMON_CLK_S2MPS11) += clk-s2mps11.o
obj-$(CONFIG_COMMON_CLK_SI5351) += clk-si5351.o
obj-$(CONFIG_COMMON_CLK_SI570) += clk-si570.o
+obj-$(CONFIG_COMMON_CLK_CDCE925) += clk-cdce925.o
obj-$(CONFIG_CLK_TWL6040) += clk-twl6040.o
obj-$(CONFIG_ARCH_U300) += clk-u300.o
obj-$(CONFIG_ARCH_VT8500) += clk-vt8500.o