tty/serial: atmel_serial: change platform_data variable name
Easier to follow if platform_data name is pdata.
Signed-off-by: Nicolas Ferre <nicolas.ferre@atmel.com>
Acked-by: Grant Likely <grant.likely@secretlab.ca>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>
diff --git a/drivers/tty/serial/atmel_serial.c b/drivers/tty/serial/atmel_serial.c
index c7232a9..a507daa 100644
--- a/drivers/tty/serial/atmel_serial.c
+++ b/drivers/tty/serial/atmel_serial.c
@@ -1417,13 +1417,13 @@
struct platform_device *pdev)
{
struct uart_port *port = &atmel_port->uart;
- struct atmel_uart_data *data = pdev->dev.platform_data;
+ struct atmel_uart_data *pdata = pdev->dev.platform_data;
port->iotype = UPIO_MEM;
port->flags = UPF_BOOT_AUTOCONF;
port->ops = &atmel_pops;
port->fifosize = 1;
- port->line = data->num;
+ port->line = pdata->num;
port->dev = &pdev->dev;
port->mapbase = pdev->resource[0].start;
port->irq = pdev->resource[1].start;
@@ -1433,9 +1433,9 @@
memset(&atmel_port->rx_ring, 0, sizeof(atmel_port->rx_ring));
- if (data->regs)
+ if (pdata->regs)
/* Already mapped by setup code */
- port->membase = data->regs;
+ port->membase = pdata->regs;
else {
port->flags |= UPF_IOREMAP;
port->membase = NULL;
@@ -1450,9 +1450,9 @@
/* only enable clock when USART is in use */
}
- atmel_port->use_dma_rx = data->use_dma_rx;
- atmel_port->use_dma_tx = data->use_dma_tx;
- atmel_port->rs485 = data->rs485;
+ atmel_port->use_dma_rx = pdata->use_dma_rx;
+ atmel_port->use_dma_tx = pdata->use_dma_tx;
+ atmel_port->rs485 = pdata->rs485;
/* Use TXEMPTY for interrupt when rs485 else TXRDY or ENDTX|TXBUFE */
if (atmel_port->rs485.flags & SER_RS485_ENABLED)
atmel_port->tx_done_mask = ATMEL_US_TXEMPTY;