serial: sh-sci: Fix race condition causing garbage during shutdown
If DMA is enabled and used, a burst of old data may be seen on the
serial console during "poweroff" or "reboot". uart_flush_buffer()
clears the circular buffer, but sci_port.tx_dma_len is not reset.
This leads to a circular buffer overflow, dumping (UART_XMIT_SIZE -
sci_port.tx_dma_len) bytes.
To fix this, add a .flush_buffer() callback that resets
sci_port.tx_dma_len.
Inspired by commit 31ca2c63fdc0aee7 ("tty/serial: atmel: fix race
condition (TX+DMA)").
Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/sh-sci.c b/drivers/tty/serial/sh-sci.c
index 71707e8..21b06cf 100644
--- a/drivers/tty/serial/sh-sci.c
+++ b/drivers/tty/serial/sh-sci.c
@@ -1558,7 +1558,16 @@
if (s->chan_rx)
sci_rx_dma_release(s, false);
}
-#else
+
+static void sci_flush_buffer(struct uart_port *port)
+{
+ /*
+ * In uart_flush_buffer(), the xmit circular buffer has just been
+ * cleared, so we have to reset tx_dma_len accordingly.
+ */
+ to_sci_port(port)->tx_dma_len = 0;
+}
+#else /* !CONFIG_SERIAL_SH_SCI_DMA */
static inline void sci_request_dma(struct uart_port *port)
{
}
@@ -1566,7 +1575,9 @@
static inline void sci_free_dma(struct uart_port *port)
{
}
-#endif
+
+#define sci_flush_buffer NULL
+#endif /* !CONFIG_SERIAL_SH_SCI_DMA */
static irqreturn_t sci_rx_interrupt(int irq, void *ptr)
{
@@ -2581,6 +2592,7 @@
.break_ctl = sci_break_ctl,
.startup = sci_startup,
.shutdown = sci_shutdown,
+ .flush_buffer = sci_flush_buffer,
.set_termios = sci_set_termios,
.pm = sci_pm,
.type = sci_type,