Linux-2.6.12-rc2
Initial git repository build. I'm not bothering with the full history,
even though we have it. We can create a separate "historical" git
archive of that later if we want to, and in the meantime it's about
3.2GB when imported into git - space that would just make the early
git days unnecessarily complicated, when we don't have a lot of good
infrastructure for it.
Let it rip!
diff --git a/Documentation/arm/SA1100/CERF b/Documentation/arm/SA1100/CERF
new file mode 100644
index 0000000..b3d8453
--- /dev/null
+++ b/Documentation/arm/SA1100/CERF
@@ -0,0 +1,29 @@
+*** The StrongARM version of the CerfBoard/Cube has been discontinued ***
+
+The Intrinsyc CerfBoard is a StrongARM 1110-based computer on a board
+that measures approximately 2" square. It includes an Ethernet
+controller, an RS232-compatible serial port, a USB function port, and
+one CompactFlash+ slot on the back. Pictures can be found at the
+Intrinsyc website, http://www.intrinsyc.com.
+
+This document describes the support in the Linux kernel for the
+Intrinsyc CerfBoard.
+
+Supported in this version:
+ - CompactFlash+ slot (select PCMCIA in General Setup and any options
+ that may be required)
+ - Onboard Crystal CS8900 Ethernet controller (Cerf CS8900A support in
+ Network Devices)
+ - Serial ports with a serial console (hardcoded to 38400 8N1)
+
+In order to get this kernel onto your Cerf, you need a server that runs
+both BOOTP and TFTP. Detailed instructions should have come with your
+evaluation kit on how to use the bootloader. This series of commands
+will suffice:
+
+ make ARCH=arm CROSS_COMPILE=arm-linux- cerfcube_defconfig
+ make ARCH=arm CROSS_COMPILE=arm-linux- zImage
+ make ARCH=arm CROSS_COMPILE=arm-linux- modules
+ cp arch/arm/boot/zImage <TFTP directory>
+
+support@intrinsyc.com