/include/ "kirkwood.dtsi"

/ {
	model = "D-Link DNS NASes (kirkwood-based)";
	compatible = "dlink,dns-kirkwood", "marvell,kirkwood-88f6281", "marvell,kirkwood";

	gpio_keys {
		compatible = "gpio-keys";
		#address-cells = <1>;
		#size-cells = <0>;
		button@1 {
			label = "Power button";
			linux,code = <116>;
			gpios = <&gpio1 2 1>;
		};
		button@2 {
			label = "USB unmount button";
			linux,code = <161>;
			gpios = <&gpio1 15 1>;
		};
		button@3 {
			label = "Reset button";
			linux,code = <0x198>;
			gpios = <&gpio1 16 1>;
		};
	};

	gpio_fan {
		/* Fan: ADDA AD045HB-G73 40mm 6000rpm@5v */
		compatible = "gpio-fan";
		gpios = <&gpio1 14 1
			 &gpio1 13 1>;
		gpio-fan,speed-map = <0    0
				      3000 1
				      6000 2>;
	};

	gpio_poweroff {
		compatible = "gpio-poweroff";
		gpios = <&gpio1 4 0>;
	};

	ocp@f1000000 {
		sata@80000 {
			status = "okay";
			nr-ports = <2>;
		};

		nand@3000000 {
			status = "okay";
			chip-delay = <35>;

			partition@0 {
				label = "u-boot";
				reg = <0x0000000 0x100000>;
				read-only;
			};

			partition@100000 {
				label = "uImage";
				reg = <0x0100000 0x500000>;
			};

			partition@600000 {
				label = "ramdisk";
				reg = <0x0600000 0x500000>;
			};

			partition@b00000 {
				label = "image";
				reg = <0x0b00000 0x6600000>;
			};

			partition@7100000 {
				label = "mini firmware";
				reg = <0x7100000 0xa00000>;
			};

			partition@7b00000 {
				label = "config";
				reg = <0x7b00000 0x500000>;
			};
		};
	};

	regulators {
		compatible = "simple-bus";
		#address-cells = <1>;
		#size-cells = <0>;

		sata0_power: regulator@1 {
			compatible = "regulator-fixed";
			reg = <1>;
			regulator-name = "SATA0 Power";
			regulator-min-microvolt = <5000000>;
			regulator-max-microvolt = <5000000>;
			enable-active-high;
			regulator-always-on;
			regulator-boot-on;
			gpio = <&gpio1 7 0>;
		};
		sata1_power: regulator@2 {
			compatible = "regulator-fixed";
			reg = <2>;
			regulator-name = "SATA1 Power";
			regulator-min-microvolt = <5000000>;
			regulator-max-microvolt = <5000000>;
			enable-active-high;
			regulator-always-on;
			regulator-boot-on;
			gpio = <&gpio1 8 0>;
		};
	};
};