drm/radeon/kms: add support for gui idle interrupts (v4)
Useful for certain power management operations. You
need to wait for the GUI engine (2D, 3D, CP, etc.) to be
idle before changing clocks or adjusting engine parameters.
(v2) Fix gui idle enable on pre-r6xx asics
(v3) The gui idle interrrupt status bit is permanently asserted
on pre-r6xx chips, but the interrrupt is still generated.
workaround it in the driver.
(v4) Add support for evergreen
Signed-off-by: Alex Deucher <alexdeucher@gmail.com>
Signed-off-by: Dave Airlie <airlied@redhat.com>
diff --git a/drivers/gpu/drm/radeon/r600.c b/drivers/gpu/drm/radeon/r600.c
index 1c85dcb..094c29d 100644
--- a/drivers/gpu/drm/radeon/r600.c
+++ b/drivers/gpu/drm/radeon/r600.c
@@ -2535,6 +2535,7 @@
u32 cp_int_cntl = CNTX_BUSY_INT_ENABLE | CNTX_EMPTY_INT_ENABLE;
u32 mode_int = 0;
u32 hpd1, hpd2, hpd3, hpd4 = 0, hpd5 = 0, hpd6 = 0;
+ u32 grbm_int_cntl = 0;
u32 hdmi1, hdmi2;
if (!rdev->irq.installed) {
@@ -2611,9 +2612,14 @@
DRM_DEBUG("r600_irq_set: hdmi 2\n");
hdmi2 |= R600_HDMI_INT_EN;
}
+ if (rdev->irq.gui_idle) {
+ DRM_DEBUG("gui idle\n");
+ grbm_int_cntl |= GUI_IDLE_INT_ENABLE;
+ }
WREG32(CP_INT_CNTL, cp_int_cntl);
WREG32(DxMODE_INT_MASK, mode_int);
+ WREG32(GRBM_INT_CNTL, grbm_int_cntl);
WREG32(R600_HDMI_BLOCK1 + R600_HDMI_CNTL, hdmi1);
if (ASIC_IS_DCE3(rdev)) {
WREG32(R600_HDMI_BLOCK3 + R600_HDMI_CNTL, hdmi2);
@@ -2929,6 +2935,11 @@
case 181: /* CP EOP event */
DRM_DEBUG("IH: CP EOP\n");
break;
+ case 233: /* GUI IDLE */
+ DRM_DEBUG("IH: CP EOP\n");
+ rdev->pm.gui_idle = true;
+ wake_up(&rdev->irq.idle_queue);
+ break;
default:
DRM_DEBUG("Unhandled interrupt: %d %d\n", src_id, src_data);
break;