xhci: replace xhci_writel() with writel()
Function xhci_writel() is used to write a 32bit value in xHC registers residing
in MMIO address space. It takes as first argument a pointer to the xhci_hcd
although it does not use it. xhci_writel() internally simply calls writel().
This creates an illusion that xhci_writel() is an xhci specific function that
has to be called in a context where a pointer to xhci_hcd is available.
Remove xhci_writel() wrapper function and replace its calls with calls to
writel() to make the code more straight-forward.
Signed-off-by: Xenia Ragiadakou <burzalodowa@gmail.com>
Signed-off-by: Sarah Sharp <sarah.a.sharp@linux.intel.com>
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 5e6a865..7630b9f 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -88,7 +88,7 @@
cmd = readl(&xhci->op_regs->command);
cmd &= mask;
- xhci_writel(xhci, cmd, &xhci->op_regs->command);
+ writel(cmd, &xhci->op_regs->command);
}
/*
@@ -128,7 +128,7 @@
temp |= (CMD_RUN);
xhci_dbg_trace(xhci, trace_xhci_dbg_init, "// Turn on HC, cmd = 0x%x.",
temp);
- xhci_writel(xhci, temp, &xhci->op_regs->command);
+ writel(temp, &xhci->op_regs->command);
/*
* Wait for the HCHalted Status bit to be 0 to indicate the host is
@@ -167,7 +167,7 @@
xhci_dbg_trace(xhci, trace_xhci_dbg_init, "// Reset the HC");
command = readl(&xhci->op_regs->command);
command |= CMD_RESET;
- xhci_writel(xhci, command, &xhci->op_regs->command);
+ writel(command, &xhci->op_regs->command);
ret = xhci_handshake(xhci, &xhci->op_regs->command,
CMD_RESET, 0, 10 * 1000 * 1000);
@@ -614,21 +614,20 @@
temp = readl(&xhci->ir_set->irq_control);
temp &= ~ER_IRQ_INTERVAL_MASK;
temp |= (u32) 160;
- xhci_writel(xhci, temp, &xhci->ir_set->irq_control);
+ writel(temp, &xhci->ir_set->irq_control);
/* Set the HCD state before we enable the irqs */
temp = readl(&xhci->op_regs->command);
temp |= (CMD_EIE);
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"// Enable interrupts, cmd = 0x%x.", temp);
- xhci_writel(xhci, temp, &xhci->op_regs->command);
+ writel(temp, &xhci->op_regs->command);
temp = readl(&xhci->ir_set->irq_pending);
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"// Enabling event ring interrupter %p by writing 0x%x to irq_pending",
xhci->ir_set, (unsigned int) ER_IRQ_ENABLE(temp));
- xhci_writel(xhci, ER_IRQ_ENABLE(temp),
- &xhci->ir_set->irq_pending);
+ writel(ER_IRQ_ENABLE(temp), &xhci->ir_set->irq_pending);
xhci_print_ir_set(xhci, 0);
if (xhci->quirks & XHCI_NEC_HOST)
@@ -699,10 +698,9 @@
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"// Disabling event ring interrupts");
temp = readl(&xhci->op_regs->status);
- xhci_writel(xhci, temp & ~STS_EINT, &xhci->op_regs->status);
+ writel(temp & ~STS_EINT, &xhci->op_regs->status);
temp = readl(&xhci->ir_set->irq_pending);
- xhci_writel(xhci, ER_IRQ_DISABLE(temp),
- &xhci->ir_set->irq_pending);
+ writel(ER_IRQ_DISABLE(temp), &xhci->ir_set->irq_pending);
xhci_print_ir_set(xhci, 0);
xhci_dbg_trace(xhci, trace_xhci_dbg_init, "cleaning up memory");
@@ -762,15 +760,15 @@
static void xhci_restore_registers(struct xhci_hcd *xhci)
{
- xhci_writel(xhci, xhci->s3.command, &xhci->op_regs->command);
- xhci_writel(xhci, xhci->s3.dev_nt, &xhci->op_regs->dev_notification);
+ writel(xhci->s3.command, &xhci->op_regs->command);
+ writel(xhci->s3.dev_nt, &xhci->op_regs->dev_notification);
xhci_write_64(xhci, xhci->s3.dcbaa_ptr, &xhci->op_regs->dcbaa_ptr);
- xhci_writel(xhci, xhci->s3.config_reg, &xhci->op_regs->config_reg);
- xhci_writel(xhci, xhci->s3.erst_size, &xhci->ir_set->erst_size);
+ writel(xhci->s3.config_reg, &xhci->op_regs->config_reg);
+ writel(xhci->s3.erst_size, &xhci->ir_set->erst_size);
xhci_write_64(xhci, xhci->s3.erst_base, &xhci->ir_set->erst_base);
xhci_write_64(xhci, xhci->s3.erst_dequeue, &xhci->ir_set->erst_dequeue);
- xhci_writel(xhci, xhci->s3.irq_pending, &xhci->ir_set->irq_pending);
- xhci_writel(xhci, xhci->s3.irq_control, &xhci->ir_set->irq_control);
+ writel(xhci->s3.irq_pending, &xhci->ir_set->irq_pending);
+ writel(xhci->s3.irq_control, &xhci->ir_set->irq_control);
}
static void xhci_set_cmd_ring_deq(struct xhci_hcd *xhci)
@@ -868,7 +866,7 @@
/* step 2: clear Run/Stop bit */
command = readl(&xhci->op_regs->command);
command &= ~CMD_RUN;
- xhci_writel(xhci, command, &xhci->op_regs->command);
+ writel(command, &xhci->op_regs->command);
/* Some chips from Fresco Logic need an extraordinary delay */
delay *= (xhci->quirks & XHCI_SLOW_SUSPEND) ? 10 : 1;
@@ -887,7 +885,7 @@
/* step 4: set CSS flag */
command = readl(&xhci->op_regs->command);
command |= CMD_CSS;
- xhci_writel(xhci, command, &xhci->op_regs->command);
+ writel(command, &xhci->op_regs->command);
if (xhci_handshake(xhci, &xhci->op_regs->status,
STS_SAVE, 0, 10 * 1000)) {
xhci_warn(xhci, "WARN: xHC save state timeout\n");
@@ -953,7 +951,7 @@
/* step 3: set CRS flag */
command = readl(&xhci->op_regs->command);
command |= CMD_CRS;
- xhci_writel(xhci, command, &xhci->op_regs->command);
+ writel(command, &xhci->op_regs->command);
if (xhci_handshake(xhci, &xhci->op_regs->status,
STS_RESTORE, 0, 10 * 1000)) {
xhci_warn(xhci, "WARN: xHC restore state timeout\n");
@@ -985,10 +983,9 @@
xhci_dbg(xhci, "// Disabling event ring interrupts\n");
temp = readl(&xhci->op_regs->status);
- xhci_writel(xhci, temp & ~STS_EINT, &xhci->op_regs->status);
+ writel(temp & ~STS_EINT, &xhci->op_regs->status);
temp = readl(&xhci->ir_set->irq_pending);
- xhci_writel(xhci, ER_IRQ_DISABLE(temp),
- &xhci->ir_set->irq_pending);
+ writel(ER_IRQ_DISABLE(temp), &xhci->ir_set->irq_pending);
xhci_print_ir_set(xhci, 0);
xhci_dbg(xhci, "cleaning up memory\n");
@@ -1025,7 +1022,7 @@
/* step 4: set Run/Stop bit */
command = readl(&xhci->op_regs->command);
command |= CMD_RUN;
- xhci_writel(xhci, command, &xhci->op_regs->command);
+ writel(command, &xhci->op_regs->command);
xhci_handshake(xhci, &xhci->op_regs->status, STS_HALT,
0, 250 * 1000);
@@ -4082,7 +4079,7 @@
spin_lock_irqsave(&xhci->lock, flags);
hlpm_val = xhci_calculate_usb2_hw_lpm_params(udev);
- xhci_writel(xhci, hlpm_val, hlpm_addr);
+ writel(hlpm_val, hlpm_addr);
/* flush write */
readl(hlpm_addr);
} else {
@@ -4091,15 +4088,15 @@
pm_val &= ~PORT_HIRD_MASK;
pm_val |= PORT_HIRD(hird) | PORT_RWE | PORT_L1DS(udev->slot_id);
- xhci_writel(xhci, pm_val, pm_addr);
+ writel(pm_val, pm_addr);
pm_val = readl(pm_addr);
pm_val |= PORT_HLE;
- xhci_writel(xhci, pm_val, pm_addr);
+ writel(pm_val, pm_addr);
/* flush write */
readl(pm_addr);
} else {
pm_val &= ~(PORT_HLE | PORT_RWE | PORT_HIRD_MASK | PORT_L1DS_MASK);
- xhci_writel(xhci, pm_val, pm_addr);
+ writel(pm_val, pm_addr);
/* flush write */
readl(pm_addr);
if (udev->usb2_hw_lpm_besl_capable) {