iwlwifi: pcie: support frag SKBs
Allow frag SKBs in PCIe and advertise the maximum number of frags
to the opmode. As a fallback. linearize the SKB if it exceeds the
maximum number of fragments. This allows using the hardware better
(filling more TBs) and should improve performance when used by the
opmode.
Also adjust tracing to be able to deal with this.
Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>
diff --git a/drivers/net/wireless/iwlwifi/iwl-trans.h b/drivers/net/wireless/iwlwifi/iwl-trans.h
index 2f79e54..e68497a 100644
--- a/drivers/net/wireless/iwlwifi/iwl-trans.h
+++ b/drivers/net/wireless/iwlwifi/iwl-trans.h
@@ -248,6 +248,8 @@
* @CMD_MAKE_TRANS_IDLE: The command response should mark the trans as idle.
* @CMD_WAKE_UP_TRANS: The command response should wake up the trans
* (i.e. mark it as non-idle).
+ * @CMD_TB_BITMAP_POS: Position of the first bit for the TB bitmap. We need to
+ * check that we leave enough room for the TBs bitmap which needs 20 bits.
*/
enum CMD_MODE {
CMD_ASYNC = BIT(0),
@@ -257,6 +259,8 @@
CMD_SEND_IN_IDLE = BIT(4),
CMD_MAKE_TRANS_IDLE = BIT(5),
CMD_WAKE_UP_TRANS = BIT(6),
+
+ CMD_TB_BITMAP_POS = 11,
};
#define DEF_CMD_PAYLOAD_SIZE 320
@@ -641,6 +645,8 @@
* @cfg - pointer to the configuration
* @status: a bit-mask of transport status flags
* @dev - pointer to struct device * that represents the device
+ * @max_skb_frags: maximum number of fragments an SKB can have when transmitted.
+ * 0 indicates that frag SKBs (NETIF_F_SG) aren't supported.
* @hw_id: a u32 with the ID of the device / sub-device.
* Set during transport allocation.
* @hw_id_str: a string with info about HW ID. Set during transport allocation.
@@ -669,6 +675,7 @@
unsigned long status;
struct device *dev;
+ u32 max_skb_frags;
u32 hw_rev;
u32 hw_id;
char hw_id_str[52];