Input: penmount - fix the protocol
The MSB and LSB of the XY axis value are switched according to the PenMount 9000 protocol. The driver name is also changed from penmountlpc, since it is not for LPC interface at all.
Signed-off-by: John Sung <penmount.touch@gmail.com>
Signed-off-by: Dmitry Torokhov <dtor@mail.ru>
diff --git a/drivers/input/touchscreen/penmount.c b/drivers/input/touchscreen/penmount.c
index c7f9ceb..3342c6d 100644
--- a/drivers/input/touchscreen/penmount.c
+++ b/drivers/input/touchscreen/penmount.c
@@ -2,6 +2,7 @@
* Penmount serial touchscreen driver
*
* Copyright (c) 2006 Rick Koch <n1gp@hotmail.com>
+ * Copyright (c) 2011 John Sung <penmount.touch@gmail.com>
*
* Based on ELO driver (drivers/input/touchscreen/elo.c)
* Copyright (c) 2004 Vojtech Pavlik
@@ -21,9 +22,10 @@
#include <linux/serio.h>
#include <linux/init.h>
-#define DRIVER_DESC "Penmount serial touchscreen driver"
+#define DRIVER_DESC "PenMount serial touchscreen driver"
MODULE_AUTHOR("Rick Koch <n1gp@hotmail.com>");
+MODULE_AUTHOR("John Sung <penmount.touch@gmail.com>");
MODULE_DESCRIPTION(DRIVER_DESC);
MODULE_LICENSE("GPL");
@@ -55,8 +57,8 @@
if (pm->data[0] & 0x80) {
if (PM_MAX_LENGTH == ++pm->idx) {
- input_report_abs(dev, ABS_X, pm->data[2] * 128 + pm->data[1]);
- input_report_abs(dev, ABS_Y, pm->data[4] * 128 + pm->data[3]);
+ input_report_abs(dev, ABS_X, pm->data[1] * 128 + pm->data[2]);
+ input_report_abs(dev, ABS_Y, pm->data[3] * 128 + pm->data[4]);
input_report_key(dev, BTN_TOUCH, !!(pm->data[0] & 0x40));
input_sync(dev);
pm->idx = 0;
@@ -84,7 +86,7 @@
/*
* pm_connect() is the routine that is called when someone adds a
- * new serio device that supports Gunze protocol and registers it as
+ * new serio device that supports PenMount protocol and registers it as
* an input device.
*/
@@ -105,7 +107,7 @@
pm->dev = input_dev;
snprintf(pm->phys, sizeof(pm->phys), "%s/input0", serio->phys);
- input_dev->name = "Penmount Serial TouchScreen";
+ input_dev->name = "PenMount Serial TouchScreen";
input_dev->phys = pm->phys;
input_dev->id.bustype = BUS_RS232;
input_dev->id.vendor = SERIO_PENMOUNT;
@@ -155,7 +157,7 @@
static struct serio_driver pm_drv = {
.driver = {
- .name = "penmountlpc",
+ .name = "serio-penmount",
},
.description = DRIVER_DESC,
.id_table = pm_serio_ids,