rbd: only set disk to read-only once
rbd_open(), called every time the device is opened, calls
set_device_ro(). There's no reason to set the device read-only or
read-write every time it is opened. Just do this once during device
setup, using set_disk_ro() instead because the struct block_device
isn't available to us there.
Signed-off-by: Josh Durgin <josh.durgin@inktank.com>
Reviewed-by: Alex Elder <elder@linaro.org>
diff --git a/drivers/block/rbd.c b/drivers/block/rbd.c
index 6423f6e..bbeb404 100644
--- a/drivers/block/rbd.c
+++ b/drivers/block/rbd.c
@@ -541,7 +541,6 @@
return -ENOENT;
(void) get_device(&rbd_dev->dev);
- set_device_ro(bdev, rbd_dev->mapping.read_only);
return 0;
}
@@ -5060,6 +5059,7 @@
if (ret)
goto err_out_disk;
set_capacity(rbd_dev->disk, rbd_dev->mapping.size / SECTOR_SIZE);
+ set_disk_ro(rbd_dev->disk, rbd_dev->mapping.read_only);
ret = rbd_bus_add_dev(rbd_dev);
if (ret)