[media] tuner-xc2028: Don't read status if device is powered down
That removes those timeout errors:
[ 3675.930940] xc2028 19-0061: Device is Xceive 3028 version 1.0, firmware version 2.7
[ 3676.060487] xc2028 19-0061: divisor= 00 00 8d d0 (freq=567.250)
[ 3676.349449] xc2028 19-0061: Putting xc2028/3028 into poweroff mode.
[ 3698.247645] xc2028 19-0061: xc2028_get_reg 0002 called
[ 3698.253276] em2860 #0: I2C transfer timeout on writing to addr 0xc2
[ 3698.253301] xc2028 19-0061: i2c input error: rc = -121 (should be 2)
[ 3698.253327] xc2028 19-0061: xc2028_signal called
[ 3698.253339] xc2028 19-0061: xc2028_get_reg 0002 called
[ 3698.259283] em2860 #0: I2C transfer timeout on writing to addr 0xc2
[ 3698.259312] xc2028 19-0061: i2c input error: rc = -121 (should be 2)
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>
diff --git a/drivers/media/tuners/tuner-xc2028.c b/drivers/media/tuners/tuner-xc2028.c
index 75afab7..cca508d 100644
--- a/drivers/media/tuners/tuner-xc2028.c
+++ b/drivers/media/tuners/tuner-xc2028.c
@@ -267,6 +267,7 @@
case XC2028_WAITING_FIRMWARE:
return -EAGAIN;
case XC2028_ACTIVE:
+ return 1;
case XC2028_SLEEP:
return 0;
case XC2028_NODEV:
@@ -913,6 +914,12 @@
if (rc < 0)
return rc;
+ /* If the device is sleeping, no channel is tuned */
+ if (!rc) {
+ *strength = 0;
+ return 0;
+ }
+
mutex_lock(&priv->lock);
/* Sync Lock Indicator */
@@ -960,6 +967,12 @@
if (rc < 0)
return rc;
+ /* If the device is sleeping, no channel is tuned */
+ if (!rc) {
+ *afc = 0;
+ return 0;
+ }
+
mutex_lock(&priv->lock);
/* Sync Lock Indicator */
@@ -1277,12 +1290,12 @@
if (rc < 0)
return rc;
- /* Avoid firmware reload on slow devices or if PM disabled */
- if (no_poweroff || priv->ctrl.disable_power_mgmt)
+ /* Device is already in sleep mode */
+ if (!rc)
return 0;
- /* Device is already in sleep mode */
- if (priv->state == XC2028_SLEEP)
+ /* Avoid firmware reload on slow devices or if PM disabled */
+ if (no_poweroff || priv->ctrl.disable_power_mgmt)
return 0;
tuner_dbg("Putting xc2028/3028 into poweroff mode.\n");