[PATCH] chardev: GPIO for SCx200 & PC-8736x: display pin values in/out in gpio_dump
Add current pin settings to gpio_dump() output. This adds the last 'word' to
the syslog lines, which displays the input and output values that the pin is
set to.
pc8736x_gpio.0: io00: 0x0044 TS OD PUE EDGE LO DEBOUNCE io:1/1
The 2 values may differ for a number of reasons:
1- the pin output circuitry is diaabled, (as the above 'TS' indicates)
2- it needs a pullup resistor to drive the attached circuit,
3- the external circuit needs a pullup so the open-drain has something
to pull-down
4- the pin is wired to Vcc or Ground
It might be appropriate to add a WARN for 2,3,4, since they could
damage the chip and/or circuit, esp if misconfig goes unnoticed.
Signed-off-by: Jim Cromie <jim.cromie@gmail.com>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>
diff --git a/drivers/char/nsc_gpio.c b/drivers/char/nsc_gpio.c
index d0b5d65..5b91e4e 100644
--- a/drivers/char/nsc_gpio.c
+++ b/drivers/char/nsc_gpio.c
@@ -26,7 +26,7 @@
u32 config = amp->gpio_config(index, ~0, 0);
/* user requested via 'v' command, so its INFO */
- dev_info(amp->dev, "io%02u: 0x%04x %s %s %s %s %s %s %s\n",
+ dev_info(amp->dev, "io%02u: 0x%04x %s %s %s %s %s %s %s\tio:%d/%d\n",
index, config,
(config & 1) ? "OE" : "TS", /* output-enabled/tristate */
(config & 2) ? "PP" : "OD", /* push pull / open drain */
@@ -34,7 +34,9 @@
(config & 8) ? "LOCKED" : "", /* locked / unlocked */
(config & 16) ? "LEVEL" : "EDGE",/* level/edge input */
(config & 32) ? "HI" : "LO", /* trigger on rise/fall edge */
- (config & 64) ? "DEBOUNCE" : ""); /* debounce */
+ (config & 64) ? "DEBOUNCE" : "", /* debounce */
+
+ amp->gpio_get(index), amp->gpio_current(index));
}
ssize_t nsc_gpio_write(struct file *file, const char __user *data,