PM / Clocks: Only disable enabled clocks in pm_clk_suspend()
Refrain from running clk_disable() on clocks that
have not been enabled. A typical case when this can
happen is during Suspend-to-RAM for devices that have
no driver associated with them. In such case the clock
may be in default ACQUIRED state.
Without this patch the sh7372 Mackerel board crashes
in __clk_disable() during Suspend-to-RAM with:
"Trying to disable clock 0xdeadbeef with 0 usecount"
This happens for the CEU device which is added during
boot. The test case has no CEU driver included in the
kernel configuration. Needed for v3.2-rc1.
Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Rafael J. Wysocki <rjw@sisk.pl>
diff --git a/drivers/base/power/clock_ops.c b/drivers/base/power/clock_ops.c
index 5f0f85d..428e55e 100644
--- a/drivers/base/power/clock_ops.c
+++ b/drivers/base/power/clock_ops.c
@@ -229,7 +229,8 @@
list_for_each_entry_reverse(ce, &psd->clock_list, node) {
if (ce->status < PCE_STATUS_ERROR) {
- clk_disable(ce->clk);
+ if (ce->status == PCE_STATUS_ENABLED)
+ clk_disable(ce->clk);
ce->status = PCE_STATUS_ACQUIRED;
}
}