Merge tag 'qcom-dt-for-4.8' of git://git.kernel.org/pub/scm/linux/kernel/git/agross/linux into next/dt
Qualcomm Device Tree Changes for v4.8
* Reverse BAM dma node reverts
* Add BAM remote control options for affected platforms
* Enable peripherals on APQ8074 dragonboard
* Enable PMA8084 pwrky
* Fix PMIC reg entries by removing unnecessary size element
* Add SCM binding and support for all currently supported boards
* Add Qualcomm WCNSS binding documentation
* Rename db600c to SD_600eval and add peripheral nodes
* Remove gpio key entry from Nexus7
* Add APQ8060 based dragonboard and associated peripherals
* Add ARMv7 PMU for IPQ4019
* Update smem state cells to match documentation
* tag 'qcom-dt-for-4.8' of git://git.kernel.org/pub/scm/linux/kernel/git/agross/linux: (26 commits)
dts: ipq4019: support ARMv7 PMU
ARM: dts: add Qualcomm APQ8060-based Dragonboard
ARM: dts: move the fixed MMC regulator to SURF board
ARM: dts: fix the MSM8660 RTC base address
ARM: dts: add I2C block in GSBI12
ARM: dts: add L2CC and RPM with regulators for MSM8660
ARM: dts: add SDCC5 to Qualcomm MSM8660
ARM: dts: add GPIO and MPP to MSM8660 PMIC
device-tree: nexus7: Remove power gpio key entry and use pmic8xxx-pwrkey
arm: dts: qcom: Update smem state cells usage
ARM: dts: qcom: msm8974-honami: Set DMA as remotely controlled
ARM: dts: sd_600eval: Fix eMMC lockup issue
ARM: dts: apq8064: rename db600c to SD_600eval
ARM: dts: apq8064: move sdcc3 pinctrls out of baord file
ARM: dts: apq8064: move sdcc1 pinctrl nodes to soc file
dt: binding: Add Qualcomm WCNSS control binding
dts: qcom: apq8064: Add SCM firmware node
dts: qcom: msm8974: Add SCM firmware node
dts: qcom: apq8084: Add SCM firmware node
dt/bindings: firmware: Add Qualcomm SCM binding
...
Signed-off-by: Olof Johansson <olof@lixom.net>