BNX2X: prevent ethtool from setting port type
On 10GBaseT boards setting the type to TP will cause the driver to try
to configure 1GBaseT.
Since there are currently no boards that support setting of the port
type, disable this for now.
Signed-off-by: Eliezer Tamir <eliezert@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
diff --git a/drivers/net/bnx2x.c b/drivers/net/bnx2x.c
index 8af142c..de32b3f 100644
--- a/drivers/net/bnx2x.c
+++ b/drivers/net/bnx2x.c
@@ -63,8 +63,8 @@
#include "bnx2x.h"
#include "bnx2x_init.h"
-#define DRV_MODULE_VERSION "1.40.22"
-#define DRV_MODULE_RELDATE "2007/11/27"
+#define DRV_MODULE_VERSION "1.42.3"
+#define DRV_MODULE_RELDATE "2008/3/9"
#define BNX2X_BC_VER 0x040200
/* Time in jiffies before concluding the transmitter is hung. */
@@ -8008,38 +8008,6 @@
cmd->duplex, cmd->port, cmd->phy_address, cmd->transceiver,
cmd->autoneg, cmd->maxtxpkt, cmd->maxrxpkt);
- switch (cmd->port) {
- case PORT_TP:
- if (!(bp->supported & SUPPORTED_TP)) {
- DP(NETIF_MSG_LINK, "TP not supported\n");
- return -EINVAL;
- }
-
- if (bp->phy_flags & PHY_XGXS_FLAG) {
- bnx2x_link_reset(bp);
- bnx2x_link_settings_supported(bp, SWITCH_CFG_1G);
- bnx2x_phy_deassert(bp);
- }
- break;
-
- case PORT_FIBRE:
- if (!(bp->supported & SUPPORTED_FIBRE)) {
- DP(NETIF_MSG_LINK, "FIBRE not supported\n");
- return -EINVAL;
- }
-
- if (!(bp->phy_flags & PHY_XGXS_FLAG)) {
- bnx2x_link_reset(bp);
- bnx2x_link_settings_supported(bp, SWITCH_CFG_10G);
- bnx2x_phy_deassert(bp);
- }
- break;
-
- default:
- DP(NETIF_MSG_LINK, "Unknown port type\n");
- return -EINVAL;
- }
-
if (cmd->autoneg == AUTONEG_ENABLE) {
if (!(bp->supported & SUPPORTED_Autoneg)) {
DP(NETIF_MSG_LINK, "Aotoneg not supported\n");