pinctrl: tegra: clear park bit for all pins
Parking bits might not be cleared by the bootloader properly (if for
instance it doesn't use the device configured by that pin). Clear
the park bits for all the pins during pinctrl probe.
This is present on T210 platforms but not earlier ones, so for earlier
generations, set parked_reg = -1 to disable.
The park bit is used to prevent glitching when reprogramming pinctrl
registers.
Based on work by:
Shravani Dingari <shravanid@nvidia.com>
Signed-off-by: Rhyland Klein <rklein@nvidia.com>
Acked-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/tegra/pinctrl-tegra.h b/drivers/pinctrl/tegra/pinctrl-tegra.h
index 1615db7..20b8934 100644
--- a/drivers/pinctrl/tegra/pinctrl-tegra.h
+++ b/drivers/pinctrl/tegra/pinctrl-tegra.h
@@ -93,6 +93,9 @@
* @tri_reg: Tri-state register offset.
* @tri_bank: Tri-state register bank.
* @tri_bit: Tri-state register bit.
+ * @parked_reg: Parked register offset. -1 if unsupported.
+ * @parked_bank: Parked register bank. 0 if unsupported.
+ * @parked_bit: Parked register bit. 0 if unsupported.
* @einput_bit: Enable-input register bit.
* @odrain_bit: Open-drain register bit.
* @lock_bit: Lock register bit.
@@ -135,13 +138,16 @@
s16 pupd_reg;
s16 tri_reg;
s16 drv_reg;
+ s16 parked_reg;
u32 mux_bank:2;
u32 pupd_bank:2;
u32 tri_bank:2;
u32 drv_bank:2;
+ u32 parked_bank:2;
s32 mux_bit:6;
s32 pupd_bit:6;
s32 tri_bit:6;
+ s32 parked_bit:6;
s32 einput_bit:6;
s32 odrain_bit:6;
s32 lock_bit:6;