pasemi_mac: Software-based LRO support
pasemi_mac: Software-based LRO support
Implement LRO for pasemi_mac. Pretty straightforward.
Signed-off-by: Olof Johansson <olof@lixom.net>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/pasemi_mac.c b/drivers/net/pasemi_mac.c
index e78aac4..98b6397 100644
--- a/drivers/net/pasemi_mac.c
+++ b/drivers/net/pasemi_mac.c
@@ -32,6 +32,7 @@
#include <linux/ip.h>
#include <linux/tcp.h>
#include <net/checksum.h>
+#include <linux/inet_lro.h>
#include <asm/irq.h>
#include <asm/firmware.h>
@@ -56,9 +57,11 @@
/* Must be a power of two */
-#define RX_RING_SIZE 1024
+#define RX_RING_SIZE 2048
#define TX_RING_SIZE 4096
+#define LRO_MAX_AGGR 64
+
#define DEFAULT_MSG_ENABLE \
(NETIF_MSG_DRV | \
NETIF_MSG_PROBE | \
@@ -206,7 +209,6 @@
return -ENOENT;
}
-
if (sscanf(maddr, "%hhx:%hhx:%hhx:%hhx:%hhx:%hhx", &addr[0],
&addr[1], &addr[2], &addr[3], &addr[4], &addr[5]) != 6) {
dev_warn(&pdev->dev,
@@ -219,6 +221,37 @@
return 0;
}
+static int get_skb_hdr(struct sk_buff *skb, void **iphdr,
+ void **tcph, u64 *hdr_flags, void *data)
+{
+ u64 macrx = (u64) data;
+ unsigned int ip_len;
+ struct iphdr *iph;
+
+ /* IPv4 header checksum failed */
+ if ((macrx & XCT_MACRX_HTY_M) != XCT_MACRX_HTY_IPV4_OK)
+ return -1;
+
+ /* non tcp packet */
+ skb_reset_network_header(skb);
+ iph = ip_hdr(skb);
+ if (iph->protocol != IPPROTO_TCP)
+ return -1;
+
+ ip_len = ip_hdrlen(skb);
+ skb_set_transport_header(skb, ip_len);
+ *tcph = tcp_hdr(skb);
+
+ /* check if ip header and tcp header are complete */
+ if (iph->tot_len < ip_len + tcp_hdrlen(skb))
+ return -1;
+
+ *hdr_flags = LRO_IPV4 | LRO_TCP;
+ *iphdr = iph;
+
+ return 0;
+}
+
static int pasemi_mac_unmap_tx_skb(struct pasemi_mac *mac,
struct sk_buff *skb,
const dma_addr_t *dmas)
@@ -662,7 +695,7 @@
skb_put(skb, len-4);
skb->protocol = eth_type_trans(skb, mac->netdev);
- netif_receive_skb(skb);
+ lro_receive_skb(&mac->lro_mgr, skb, (void *)macrx);
next:
RX_DESC(rx, n) = 0;
@@ -684,6 +717,8 @@
rx_ring(mac)->next_to_clean = n;
+ lro_flush_all(&mac->lro_mgr);
+
/* Increase is in number of 16-byte entries, and since each descriptor
* with an 8BRES takes up 3x8 bytes (padded to 4x8), increase with
* count*2.
@@ -988,7 +1023,7 @@
PAS_IOB_DMA_COM_TIMEOUTCFG_TCNT(0x3ff));
write_iob_reg(PAS_IOB_DMA_RXCH_CFG(mac->rx->chan.chno),
- PAS_IOB_DMA_RXCH_CFG_CNTTH(128));
+ PAS_IOB_DMA_RXCH_CFG_CNTTH(256));
write_iob_reg(PAS_IOB_DMA_TXCH_CFG(mac->tx->chan.chno),
PAS_IOB_DMA_TXCH_CFG_CNTTH(32));
@@ -1368,6 +1403,16 @@
dev->features = NETIF_F_IP_CSUM | NETIF_F_LLTX | NETIF_F_SG |
NETIF_F_HIGHDMA;
+ mac->lro_mgr.max_aggr = LRO_MAX_AGGR;
+ mac->lro_mgr.max_desc = MAX_LRO_DESCRIPTORS;
+ mac->lro_mgr.lro_arr = mac->lro_desc;
+ mac->lro_mgr.get_skb_header = get_skb_hdr;
+ mac->lro_mgr.features = LRO_F_NAPI | LRO_F_EXTRACT_VLAN_ID;
+ mac->lro_mgr.dev = mac->netdev;
+ mac->lro_mgr.ip_summed = CHECKSUM_UNNECESSARY;
+ mac->lro_mgr.ip_summed_aggr = CHECKSUM_UNNECESSARY;
+
+
mac->dma_pdev = pci_get_device(PCI_VENDOR_ID_PASEMI, 0xa007, NULL);
if (!mac->dma_pdev) {
dev_err(&mac->pdev->dev, "Can't find DMA Controller\n");