net/mlx5: TX WQE update
Add new TX WQE fields for Connect-X5 vlan insertion support,
type and vlan_tci, when type = MLX5_ETH_WQE_INSERT_VLAN the
HW will insert the vlan and prio fields (vlan_tci) to the packet.
Those bits and the inline header fields are mutually exclusive, and
valid only when:
MLX5_CAP_ETH(mdev, wqe_inline_mode) == MLX5_CAP_INLINE_MODE_NOT_REQUIRED
and MLX5_CAP_ETH(mdev, wqe_vlan_insert),
who will be set in ConnectX-5 and later HW generations.
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>
Reviewed-by: Tariq Toukan <tariqt@mellanox.com>
diff --git a/drivers/infiniband/hw/mlx5/qp.c b/drivers/infiniband/hw/mlx5/qp.c
index 6a83fb3..e31bf11 100644
--- a/drivers/infiniband/hw/mlx5/qp.c
+++ b/drivers/infiniband/hw/mlx5/qp.c
@@ -2984,20 +2984,20 @@
if (wr->opcode == IB_WR_LSO) {
struct ib_ud_wr *ud_wr = container_of(wr, struct ib_ud_wr, wr);
- int size_of_inl_hdr_start = sizeof(eseg->inline_hdr_start);
+ int size_of_inl_hdr_start = sizeof(eseg->inline_hdr.start);
u64 left, leftlen, copysz;
void *pdata = ud_wr->header;
left = ud_wr->hlen;
eseg->mss = cpu_to_be16(ud_wr->mss);
- eseg->inline_hdr_sz = cpu_to_be16(left);
+ eseg->inline_hdr.sz = cpu_to_be16(left);
/*
* check if there is space till the end of queue, if yes,
* copy all in one shot, otherwise copy till the end of queue,
* rollback and than the copy the left
*/
- leftlen = qend - (void *)eseg->inline_hdr_start;
+ leftlen = qend - (void *)eseg->inline_hdr.start;
copysz = min_t(u64, leftlen, left);
memcpy(seg - size_of_inl_hdr_start, pdata, copysz);