wil6210: work around for platforms with broken INTx
There are platforms where INTx can't be routed by ACPI,
this leads to pci_enable_device failure. Re-try pretending we have
MSI already configured; in this case pci_enable_device do not try
to configure INTx. However, MSI could still work.
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/ath/wil6210/pcie_bus.c b/drivers/net/wireless/ath/wil6210/pcie_bus.c
index 05c1c9d..77b6272 100644
--- a/drivers/net/wireless/ath/wil6210/pcie_bus.c
+++ b/drivers/net/wireless/ath/wil6210/pcie_bus.c
@@ -35,6 +35,13 @@
{
struct pci_dev *pdev = wil->pdev;
int rc;
+ /* on platforms with buggy ACPI, pdev->msi_enabled may be set to
+ * allow pci_enable_device to work. This indicates INTx was not routed
+ * and only MSI should be used
+ */
+ int msi_only = pdev->msi_enabled;
+
+ pdev->msi_enabled = 0;
pci_set_master(pdev);
@@ -66,6 +73,12 @@
wil->n_msi = use_msi;
+ if ((wil->n_msi == 0) && msi_only) {
+ wil_err(wil, "Interrupt pin not routed, unable to use INTx\n");
+ rc = -ENODEV;
+ goto stop_master;
+ }
+
rc = wil6210_init_irq(wil, pdev->irq);
if (rc)
goto stop_master;
@@ -124,9 +137,16 @@
rc = pci_enable_device(pdev);
if (rc) {
- dev_err(&pdev->dev, "pci_enable_device failed\n");
- return -ENODEV;
+ dev_err(&pdev->dev,
+ "pci_enable_device failed, retry with MSI only\n");
+ /* Work around for platforms that can't allocate IRQ:
+ * retry with MSI only
+ */
+ pdev->msi_enabled = 1;
+ rc = pci_enable_device(pdev);
}
+ if (rc)
+ return -ENODEV;
/* rollback to err_disable_pdev */
rc = pci_request_region(pdev, 0, WIL_NAME);