CRIS: avoid using arch links in Kconfig
Improve including of architecture dependent Kconfig files.
- Always include the architecture dependent Kconfig files.
- Wrap architecture dependent Kconfig files inside an appropriate
"if ETRAX_ARCH_Vxx" block.
This makes it possible to run the configuration even without the arch links,
which are created later in the build process.
Signed-off-by: Jesper Nilsson <jesper.nilsson@axis.com>
Acked-by: Sam Ravnborg <sam@ravnborg.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/arch/cris/Kconfig b/arch/cris/Kconfig
index 7f0be4c..27b082a 100644
--- a/arch/cris/Kconfig
+++ b/arch/cris/Kconfig
@@ -150,6 +150,7 @@
Width in bytes of the Flash bus (1, 2 or 4). Is usually 2.
source arch/cris/arch-v10/Kconfig
+source arch/cris/arch-v32/Kconfig
endmenu
@@ -157,8 +158,8 @@
# bring in ETRAX built-in drivers
menu "Drivers for built-in interfaces"
-# arch/cris/arch is a symlink to correct arch (arch-v10 or arch-v32)
-source arch/cris/arch/drivers/Kconfig
+source arch/cris/arch-v10/drivers/Kconfig
+source arch/cris/arch-v32/drivers/Kconfig
endmenu