[netdrvr] Use dev_printk() when ethernet interface isn't available
For messages prior to register_netdev(), prefer dev_printk() because
that prints out both our driver name and our [PCI | whatever] bus id.
Updates: 8139{cp,too}, b44, bnx2, cassini, {eepro,epic}100, fealnx,
hamachi, ne2k-pci, ns83820, pci-skeleton, r8169.
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/ne2k-pci.c b/drivers/net/ne2k-pci.c
index fa50eb8..4f22606 100644
--- a/drivers/net/ne2k-pci.c
+++ b/drivers/net/ne2k-pci.c
@@ -231,12 +231,14 @@
irq = pdev->irq;
if (!ioaddr || ((pci_resource_flags (pdev, 0) & IORESOURCE_IO) == 0)) {
- printk (KERN_ERR PFX "no I/O resource at PCI BAR #0\n");
+ dev_printk (KERN_ERR, &pdev->dev,
+ "no I/O resource at PCI BAR #0\n");
return -ENODEV;
}
if (request_region (ioaddr, NE_IO_EXTENT, DRV_NAME) == NULL) {
- printk (KERN_ERR PFX "I/O resource 0x%x @ 0x%lx busy\n",
+ dev_printk (KERN_ERR, &pdev->dev,
+ "I/O resource 0x%x @ 0x%lx busy\n",
NE_IO_EXTENT, ioaddr);
return -EBUSY;
}
@@ -263,7 +265,8 @@
/* Allocate net_device, dev->priv; fill in 8390 specific dev fields. */
dev = alloc_ei_netdev();
if (!dev) {
- printk (KERN_ERR PFX "cannot allocate ethernet device\n");
+ dev_printk (KERN_ERR, &pdev->dev,
+ "cannot allocate ethernet device\n");
goto err_out_free_res;
}
SET_MODULE_OWNER(dev);
@@ -281,7 +284,8 @@
while ((inb(ioaddr + EN0_ISR) & ENISR_RESET) == 0)
/* Limit wait: '2' avoids jiffy roll-over. */
if (jiffies - reset_start_time > 2) {
- printk(KERN_ERR PFX "Card failure (no reset ack).\n");
+ dev_printk(KERN_ERR, &pdev->dev,
+ "Card failure (no reset ack).\n");
goto err_out_free_netdev;
}