drm/i915: add port power domains
Parts that poke port specific HW blocks like the encoder HW state
readout or connector hotplug detect code need a way to check whether
required power domains are on or enable/disable these. For this purpose
add a set of power domains that refer to the port HW blocks. Get the
proper port power domains during modeset.
For now when requesting the power domain for a DDI port get it for a 4
lane configuration. This can be optimized later to request only the 2
lane power domain, when proper support is added on the VLV PHY side for
this. Atm, the PHY setup code assumes a 4 lane config in all cases.
Signed-off-by: Imre Deak <imre.deak@intel.com>
Reviewed-by: Jesse Barnes <jbarnes@virtuousgeek.org>
Signed-off-by: Daniel Vetter <daniel.vetter@ffwll.ch>
diff --git a/drivers/gpu/drm/i915/i915_debugfs.c b/drivers/gpu/drm/i915/i915_debugfs.c
index fbcf536..a90d31c 100644
--- a/drivers/gpu/drm/i915/i915_debugfs.c
+++ b/drivers/gpu/drm/i915/i915_debugfs.c
@@ -2048,6 +2048,28 @@
return "TRANSCODER_C";
case POWER_DOMAIN_TRANSCODER_EDP:
return "TRANSCODER_EDP";
+ case POWER_DOMAIN_PORT_DDI_A_2_LANES:
+ return "PORT_DDI_A_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_A_4_LANES:
+ return "PORT_DDI_A_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_B_2_LANES:
+ return "PORT_DDI_B_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_B_4_LANES:
+ return "PORT_DDI_B_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_C_2_LANES:
+ return "PORT_DDI_C_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_C_4_LANES:
+ return "PORT_DDI_C_4_LANES";
+ case POWER_DOMAIN_PORT_DDI_D_2_LANES:
+ return "PORT_DDI_D_2_LANES";
+ case POWER_DOMAIN_PORT_DDI_D_4_LANES:
+ return "PORT_DDI_D_4_LANES";
+ case POWER_DOMAIN_PORT_DSI:
+ return "PORT_DSI";
+ case POWER_DOMAIN_PORT_CRT:
+ return "PORT_CRT";
+ case POWER_DOMAIN_PORT_OTHER:
+ return "PORT_OTHER";
case POWER_DOMAIN_VGA:
return "VGA";
case POWER_DOMAIN_AUDIO:
diff --git a/drivers/gpu/drm/i915/i915_drv.h b/drivers/gpu/drm/i915/i915_drv.h
index 9e26103..9387c56 100644
--- a/drivers/gpu/drm/i915/i915_drv.h
+++ b/drivers/gpu/drm/i915/i915_drv.h
@@ -114,6 +114,17 @@
POWER_DOMAIN_TRANSCODER_B,
POWER_DOMAIN_TRANSCODER_C,
POWER_DOMAIN_TRANSCODER_EDP,
+ POWER_DOMAIN_PORT_DDI_A_2_LANES,
+ POWER_DOMAIN_PORT_DDI_A_4_LANES,
+ POWER_DOMAIN_PORT_DDI_B_2_LANES,
+ POWER_DOMAIN_PORT_DDI_B_4_LANES,
+ POWER_DOMAIN_PORT_DDI_C_2_LANES,
+ POWER_DOMAIN_PORT_DDI_C_4_LANES,
+ POWER_DOMAIN_PORT_DDI_D_2_LANES,
+ POWER_DOMAIN_PORT_DDI_D_4_LANES,
+ POWER_DOMAIN_PORT_DSI,
+ POWER_DOMAIN_PORT_CRT,
+ POWER_DOMAIN_PORT_OTHER,
POWER_DOMAIN_VGA,
POWER_DOMAIN_AUDIO,
POWER_DOMAIN_INIT,
diff --git a/drivers/gpu/drm/i915/intel_display.c b/drivers/gpu/drm/i915/intel_display.c
index ee786c5..414da19 100644
--- a/drivers/gpu/drm/i915/intel_display.c
+++ b/drivers/gpu/drm/i915/intel_display.c
@@ -3962,9 +3962,49 @@
for ((domain) = 0; (domain) < POWER_DOMAIN_NUM; (domain)++) \
if ((1 << (domain)) & (mask))
-static unsigned long get_pipe_power_domains(struct drm_device *dev,
- enum pipe pipe, bool pfit_enabled)
+enum intel_display_power_domain
+intel_display_port_power_domain(struct intel_encoder *intel_encoder)
{
+ struct drm_device *dev = intel_encoder->base.dev;
+ struct intel_digital_port *intel_dig_port;
+
+ switch (intel_encoder->type) {
+ case INTEL_OUTPUT_UNKNOWN:
+ /* Only DDI platforms should ever use this output type */
+ WARN_ON_ONCE(!HAS_DDI(dev));
+ case INTEL_OUTPUT_DISPLAYPORT:
+ case INTEL_OUTPUT_HDMI:
+ case INTEL_OUTPUT_EDP:
+ intel_dig_port = enc_to_dig_port(&intel_encoder->base);
+ switch (intel_dig_port->port) {
+ case PORT_A:
+ return POWER_DOMAIN_PORT_DDI_A_4_LANES;
+ case PORT_B:
+ return POWER_DOMAIN_PORT_DDI_B_4_LANES;
+ case PORT_C:
+ return POWER_DOMAIN_PORT_DDI_C_4_LANES;
+ case PORT_D:
+ return POWER_DOMAIN_PORT_DDI_D_4_LANES;
+ default:
+ WARN_ON_ONCE(1);
+ return POWER_DOMAIN_PORT_OTHER;
+ }
+ case INTEL_OUTPUT_ANALOG:
+ return POWER_DOMAIN_PORT_CRT;
+ case INTEL_OUTPUT_DSI:
+ return POWER_DOMAIN_PORT_DSI;
+ default:
+ return POWER_DOMAIN_PORT_OTHER;
+ }
+}
+
+static unsigned long get_crtc_power_domains(struct drm_crtc *crtc)
+{
+ struct drm_device *dev = crtc->dev;
+ struct intel_encoder *intel_encoder;
+ struct intel_crtc *intel_crtc = to_intel_crtc(crtc);
+ enum pipe pipe = intel_crtc->pipe;
+ bool pfit_enabled = intel_crtc->config.pch_pfit.enabled;
unsigned long mask;
enum transcoder transcoder;
@@ -3975,6 +4015,9 @@
if (pfit_enabled)
mask |= BIT(POWER_DOMAIN_PIPE_PANEL_FITTER(pipe));
+ for_each_encoder_on_crtc(dev, crtc, intel_encoder)
+ mask |= BIT(intel_display_port_power_domain(intel_encoder));
+
return mask;
}
@@ -4008,9 +4051,7 @@
if (!crtc->base.enabled)
continue;
- pipe_domains[crtc->pipe] = get_pipe_power_domains(dev,
- crtc->pipe,
- crtc->config.pch_pfit.enabled);
+ pipe_domains[crtc->pipe] = get_crtc_power_domains(&crtc->base);
for_each_power_domain(domain, pipe_domains[crtc->pipe])
intel_display_power_get(dev_priv, domain);
diff --git a/drivers/gpu/drm/i915/intel_drv.h b/drivers/gpu/drm/i915/intel_drv.h
index 6042797..e31eb1e 100644
--- a/drivers/gpu/drm/i915/intel_drv.h
+++ b/drivers/gpu/drm/i915/intel_drv.h
@@ -733,6 +733,8 @@
void hsw_enable_ips(struct intel_crtc *crtc);
void hsw_disable_ips(struct intel_crtc *crtc);
void intel_display_set_init_power(struct drm_i915_private *dev, bool enable);
+enum intel_display_power_domain
+intel_display_port_power_domain(struct intel_encoder *intel_encoder);
int valleyview_get_vco(struct drm_i915_private *dev_priv);
void intel_mode_from_pipe_config(struct drm_display_mode *mode,
struct intel_crtc_config *pipe_config);
diff --git a/drivers/gpu/drm/i915/intel_pm.c b/drivers/gpu/drm/i915/intel_pm.c
index 37f1621..a4c0ff1 100644
--- a/drivers/gpu/drm/i915/intel_pm.c
+++ b/drivers/gpu/drm/i915/intel_pm.c
@@ -5483,6 +5483,15 @@
#define HSW_ALWAYS_ON_POWER_DOMAINS ( \
BIT(POWER_DOMAIN_PIPE_A) | \
BIT(POWER_DOMAIN_TRANSCODER_EDP) | \
+ BIT(POWER_DOMAIN_PORT_DDI_A_2_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_A_4_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_B_2_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_B_4_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_C_2_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_C_4_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_D_2_LANES) | \
+ BIT(POWER_DOMAIN_PORT_DDI_D_4_LANES) | \
+ BIT(POWER_DOMAIN_PORT_CRT) | \
BIT(POWER_DOMAIN_INIT))
#define HSW_DISPLAY_POWER_DOMAINS ( \
(POWER_DOMAIN_MASK & ~HSW_ALWAYS_ON_POWER_DOMAINS) | \