[PATCH] wireless Kconfig add IPW2200_RADIOTAP
Makefile both IPW2200_RADIOTAP and IPW2200_PROMISCUOUS depend on
IPW2200_MONITOR. Let IPW2200_PROMISCUOUS select IPW2200_RADIOTAP.
Signed-off-by: Zhu Yi <yi.zhu@intel.com>
Signed-off-by: John W. Linville <linville@tuxdriver.com>
diff --git a/drivers/net/wireless/Kconfig b/drivers/net/wireless/Kconfig
index 19bc099..d7691c4 100644
--- a/drivers/net/wireless/Kconfig
+++ b/drivers/net/wireless/Kconfig
@@ -235,6 +235,34 @@
promiscuous mode via the Wireless Tool's Monitor mode. While in this
mode, no packets can be sent.
+config IPW2200_RADIOTAP
+ bool "Enable radiotap format 802.11 raw packet support"
+ depends on IPW2200_MONITOR
+
+config IPW2200_PROMISCUOUS
+ bool "Enable creation of a RF radiotap promiscuous interface"
+ depends on IPW2200_MONITOR
+ select IPW2200_RADIOTAP
+ ---help---
+ Enables the creation of a second interface prefixed 'rtap'.
+ This second interface will provide every received in radiotap
+ format.
+
+ This is useful for performing wireless network analysis while
+ maintaining an active association.
+
+ Example usage:
+
+ % modprobe ipw2200 rtap_iface=1
+ % ifconfig rtap0 up
+ % tethereal -i rtap0
+
+ If you do not specify 'rtap_iface=1' as a module parameter then
+ the rtap interface will not be created and you will need to turn
+ it on via sysfs:
+
+ % echo 1 > /sys/bus/pci/drivers/ipw2200/*/rtap_iface
+
config IPW2200_QOS
bool "Enable QoS support"
depends on IPW2200 && EXPERIMENTAL
@@ -263,30 +291,6 @@
If you are not trying to debug or develop the IPW2200 driver, you
most likely want to say N here.
-config IPW2200_PROMISCUOUS
- bool "Enable creation of a RF radiotap promiscuous interface."
- depends on IPW2200
- select IEEE80211_RADIOTAP
- ---help---
- Enables the creation of a second interface prefixed 'rtap'.
- This second interface will provide every received in radiotap
- format.
-
- This is useful for performing wireless network analysis while
- maintaining an active association.
-
- Example usage:
-
- % modprobe ipw2200 rtap_iface=1
- % ifconfig rtap0 up
- % tethereal -i rtap0
-
- If you do not specify 'rtap_iface=1' as a module parameter then
- the rtap interface will not be created and you will need to turn
- it on via sysfs:
-
- % echo 1 > /sys/bus/pci/drivers/ipw2200/*/rtap_iface
-
config AIRO
tristate "Cisco/Aironet 34X/35X/4500/4800 ISA and PCI cards"
depends on NET_RADIO && ISA_DMA_API && (PCI || BROKEN)