rtl8xxxu: Initial rtl8723bu chip identification
This provides initial detection of 8723bu devices, and selects the
correct firmware image to load.
Signed-off-by: Jes Sorensen <Jes.Sorensen@redhat.com>
Signed-off-by: Kalle Valo <kvalo@codeaurora.org>
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
index e4d8127..729f6d2 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.c
@@ -55,6 +55,8 @@
MODULE_FIRMWARE("rtlwifi/rtl8192cufw_B.bin");
MODULE_FIRMWARE("rtlwifi/rtl8192cufw_TMSC.bin");
MODULE_FIRMWARE("rtlwifi/rtl8192eu_nic.bin");
+MODULE_FIRMWARE("rtlwifi/rtl8723bu_nic.bin");
+MODULE_FIRMWARE("rtlwifi/rtl8723bu_bt.bin");
module_param_named(debug, rtl8xxxu_debug, int, 0600);
MODULE_PARM_DESC(debug, "Set debug mask");
@@ -1700,11 +1702,17 @@
}
if (val32 & SYS_CFG_BT_FUNC) {
- sprintf(priv->chip_name, "8723AU");
+ if (priv->chip_cut >= 3) {
+ sprintf(priv->chip_name, "8723BU");
+ priv->rtlchip = 0x8723b;
+ } else {
+ sprintf(priv->chip_name, "8723AU");
+ priv->rtlchip = 0x8723a;
+ }
+
priv->rf_paths = 1;
priv->rx_paths = 1;
priv->tx_paths = 1;
- priv->rtlchip = 0x8723a;
val32 = rtl8xxxu_read32(priv, REG_MULTI_FUNC_CTRL);
if (val32 & MULTI_WIFI_FUNC_EN)
@@ -1807,6 +1815,7 @@
*/
if (!priv->ep_tx_count) {
switch (priv->nr_out_eps) {
+ case 4:
case 3:
priv->ep_tx_low_queue = 1;
priv->ep_tx_count++;
@@ -2321,6 +2330,7 @@
case 0x92e0:
case 0x92c0:
case 0x88c0:
+ case 0x5300:
case 0x2300:
break;
default:
@@ -2362,6 +2372,20 @@
return ret;
}
+static int rtl8723bu_load_firmware(struct rtl8xxxu_priv *priv)
+{
+ char *fw_name;
+ int ret;
+
+ if (priv->enable_bluetooth)
+ fw_name = "rtlwifi/rtl8723bu_bt.bin";
+ else
+ fw_name = "rtlwifi/rtl8723bu_nic.bin";
+
+ ret = rtl8xxxu_load_firmware(priv, fw_name);
+ return ret;
+}
+
#ifdef CONFIG_RTL8XXXU_UNTESTED
static int rtl8192cu_load_firmware(struct rtl8xxxu_priv *priv)
@@ -2587,7 +2611,7 @@
else
rtl8xxxu_init_phy_regs(priv, rtl8xxx_agc_standard_table);
- if (priv->rtlchip == 0x8723a &&
+ if ((priv->rtlchip == 0x8723a || priv->rtlchip == 0x8723b) &&
priv->efuse_wifi.efuse8723.version >= 0x01) {
val32 = rtl8xxxu_read32(priv, REG_MAC_PHY_CTRL);
@@ -6117,6 +6141,14 @@
.writeN_block_size = 1024,
};
+static struct rtl8xxxu_fileops rtl8723bu_fops = {
+ .parse_efuse = rtl8723au_parse_efuse,
+ .load_firmware = rtl8723bu_load_firmware,
+ .power_on = rtl8723au_power_on,
+ .llt_init = rtl8xxxu_auto_llt_table,
+ .writeN_block_size = 128,
+};
+
#ifdef CONFIG_RTL8XXXU_UNTESTED
static struct rtl8xxxu_fileops rtl8192cu_fops = {
@@ -6146,6 +6178,8 @@
.driver_info = (unsigned long)&rtl8723au_fops},
{USB_DEVICE_AND_INTERFACE_INFO(USB_VENDOR_ID_REALTEK, 0x818b, 0xff, 0xff, 0xff),
.driver_info = (unsigned long)&rtl8192eu_fops},
+{USB_DEVICE_AND_INTERFACE_INFO(USB_VENDOR_ID_REALTEK, 0xb720, 0xff, 0xff, 0xff),
+ .driver_info = (unsigned long)&rtl8723bu_fops},
#ifdef CONFIG_RTL8XXXU_UNTESTED
/* Still supported by rtlwifi */
{USB_DEVICE_AND_INTERFACE_INFO(USB_VENDOR_ID_REALTEK, 0x8176, 0xff, 0xff, 0xff),
diff --git a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h
index 56c4e0a..dd4c563 100644
--- a/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h
+++ b/drivers/net/wireless/realtek/rtl8xxxu/rtl8xxxu.h
@@ -34,7 +34,7 @@
#define RTL8XXXU_MAX_REG_POLL 500
#define USB_INTR_CONTENT_LENGTH 56
-#define RTL8XXXU_OUT_ENDPOINTS 3
+#define RTL8XXXU_OUT_ENDPOINTS 4
#define REALTEK_USB_READ 0xc0
#define REALTEK_USB_WRITE 0x40