ARM: dts: imx6ul-isiot-common: Add touchscreen node
Add touchscreen node as i2c1 slave device on Engicam Is.IoT MX6UL
modules, the touchscreen controlled 'st,stmpe-ts' connected via
i2c with st,stmpe811 mfd interface.
Cc: Matteo Lisi <matteo.lisi@engicam.com>
Cc: Michael Trimarchi <michael@amarulasolutions.com>
Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
Signed-off-by: Shawn Guo <shawnguo@kernel.org>
diff --git a/arch/arm/boot/dts/imx6ul-isiot-common.dtsi b/arch/arm/boot/dts/imx6ul-isiot-common.dtsi
index 9660e20..2beaab6 100644
--- a/arch/arm/boot/dts/imx6ul-isiot-common.dtsi
+++ b/arch/arm/boot/dts/imx6ul-isiot-common.dtsi
@@ -40,6 +40,34 @@
* OTHER DEALINGS IN THE SOFTWARE.
*/
+&i2c1 {
+ stmpe811: gpio-expander@44 {
+ compatible = "st,stmpe811";
+ reg = <0x44>;
+ #address-cells = <1>;
+ #size-cells = <0>;
+ pinctrl-names = "default";
+ pinctrl-0 = <&pinctrl_stmpe>;
+ interrupt-parent = <&gpio1>;
+ interrupts = <18 IRQ_TYPE_EDGE_FALLING>;
+ interrupt-controller;
+ #interrupt-cells = <2>;
+
+ stmpe: touchscreen {
+ compatible = "st,stmpe-ts";
+ st,sample-time = <4>;
+ st,mod-12b = <1>;
+ st,ref-sel = <0>;
+ st,adc-freq = <1>;
+ st,ave-ctrl = <1>;
+ st,touch-det-delay = <2>;
+ st,settling = <2>;
+ st,fraction-z = <7>;
+ st,i-drive = <1>;
+ };
+ };
+};
+
&lcdif {
pinctrl-names = "default";
pinctrl-0 = <&pinctrl_lcdif_dat
@@ -104,4 +132,10 @@
MX6UL_PAD_LCD_DATA17__LCDIF_DATA17 0x79
>;
};
+
+ pinctrl_stmpe: stmpegrp {
+ fsl,pins = <
+ MX6UL_PAD_UART1_CTS_B__GPIO1_IO18 0x1b0b0
+ >;
+ };
};