ASoC: ak4104: add reset line property to DT bindings
This device doesn't have a pdata definition for legacy boards, and
unless anyone need to control the reset GPIO, it's not worth adding one.
So this feature is only available to DT users for now.
Signed-off-by: Daniel Mack <zonque@gmail.com>
Signed-off-by: Mark Brown <broonie@opensource.wolfsonmicro.com>
diff --git a/Documentation/devicetree/bindings/sound/ak4104.txt b/Documentation/devicetree/bindings/sound/ak4104.txt
index 1f8e506..b902ee3 100644
--- a/Documentation/devicetree/bindings/sound/ak4104.txt
+++ b/Documentation/devicetree/bindings/sound/ak4104.txt
@@ -8,6 +8,11 @@
- reg : The chip select number on the SPI bus
+Optional properties:
+
+ - reset-gpio : a GPIO spec for the reset pin. If specified, it will be
+ deasserted before communication to the device starts.
+
Example:
spdif: ak4104@0 {
diff --git a/sound/soc/codecs/ak4104.c b/sound/soc/codecs/ak4104.c
index d4d4858..eec086b 100644
--- a/sound/soc/codecs/ak4104.c
+++ b/sound/soc/codecs/ak4104.c
@@ -15,6 +15,8 @@
#include <sound/soc.h>
#include <sound/initval.h>
#include <linux/spi/spi.h>
+#include <linux/of_device.h>
+#include <linux/of_gpio.h>
#include <sound/asoundef.h>
/* AK4104 registers addresses */
@@ -204,6 +206,7 @@
static int ak4104_spi_probe(struct spi_device *spi)
{
+ struct device_node *np = spi->dev.of_node;
struct ak4104_private *ak4104;
unsigned int val;
int ret;
@@ -225,6 +228,20 @@
return ret;
}
+ if (np) {
+ enum of_gpio_flags flags;
+ int gpio = of_get_named_gpio_flags(np, "reset-gpio", 0, &flags);
+
+ if (gpio_is_valid(gpio)) {
+ ret = devm_gpio_request_one(&spi->dev, gpio,
+ flags & OF_GPIO_ACTIVE_LOW ?
+ GPIOF_OUT_INIT_LOW : GPIOF_OUT_INIT_HIGH,
+ "ak4104 reset");
+ if (ret < 0)
+ return ret;
+ }
+ }
+
/* read the 'reserved' register - according to the datasheet, it
* should contain 0x5b. Not a good way to verify the presence of
* the device, but there is no hardware ID register. */