NCR53C8XX: Remove deprecated IRQ flags (SA_*)
Stop using deprecated IRQ flags in ncr53c8xx documentaion. The new IRQF_*
macros are used instead.
Signed-off-by: Ahmed S. Darwish <darwish.07@gmail.com>
Cc: James Bottomley <James.Bottomley@steeleye.com>
Cc: Matthew Wilcox <willy@debian.org>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>
diff --git a/Documentation/scsi/ChangeLog.ncr53c8xx b/Documentation/scsi/ChangeLog.ncr53c8xx
index 7d03e9d..a9f721a 100644
--- a/Documentation/scsi/ChangeLog.ncr53c8xx
+++ b/Documentation/scsi/ChangeLog.ncr53c8xx
@@ -195,9 +195,9 @@
Pointed out by Leonard Zubkoff.
- Allow to tune request_irq() flags from the boot command line using
ncr53c8xx=irqm:??, as follows:
- a) If bit 0x10 is set in irqm, SA_SHIRQ flag is not used.
- b) If bit 0x20 is set in irqm, SA_INTERRUPT flag is not used.
- By default the driver uses both SA_SHIRQ and SA_INTERRUPT.
+ a) If bit 0x10 is set in irqm, IRQF_SHARED flag is not used.
+ b) If bit 0x20 is set in irqm, IRQF_DISABLED flag is not used.
+ By default the driver uses both IRQF_SHARED and IRQF_DISABLED.
Option 'ncr53c8xx=irqm:0x20' may be used when an IRQ is shared by
a 53C8XX adapter and a network board.
- Tiny mispelling fixed (ABORT instead of ABRT). Was fortunately