spidernet: checksum and ethtool
It doesn't look like spidernet hardware can really checksum all protocols,
the code looks like it does IPV4 only. If so, it should use NETIF_F_IP_CSUM
instead of NETIF_F_HW_CSUM.
The driver doesn't need it's own get/set for ethtool tx csum, and it
should use the standard ethtool_op_get_link.
Signed-off-by: Stephen Hemminger <shemminger@linux-foundation.org>
Signed-off-by: Linas Vepstas <linas@austin.ibm.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>
diff --git a/drivers/net/spider_net.c b/drivers/net/spider_net.c
index 0e79bac..7a4aa6a 100644
--- a/drivers/net/spider_net.c
+++ b/drivers/net/spider_net.c
@@ -718,7 +718,7 @@
SPIDER_NET_DESCR_CARDOWNED | SPIDER_NET_DMAC_NOCS;
spin_unlock_irqrestore(&chain->lock, flags);
- if (skb->protocol == htons(ETH_P_IP) && skb->ip_summed == CHECKSUM_PARTIAL)
+ if (skb->ip_summed == CHECKSUM_PARTIAL)
switch (ip_hdr(skb)->protocol) {
case IPPROTO_TCP:
hwdescr->dmac_cmd_status |= SPIDER_NET_DMAC_TCP;
@@ -2260,7 +2260,7 @@
spider_net_setup_netdev_ops(netdev);
- netdev->features = NETIF_F_HW_CSUM | NETIF_F_LLTX;
+ netdev->features = NETIF_F_IP_CSUM | NETIF_F_LLTX;
/* some time: NETIF_F_HW_VLAN_TX | NETIF_F_HW_VLAN_RX |
* NETIF_F_HW_VLAN_FILTER */