[SCSI] NCR_D700: misc fixes (section and argument ordering)
Apparently the D700 has had an argument ordering issue for quite a while
which can cause it to get the wrong scsi_id (I just got an unbootable
voyager system because of this). Hopefully this patch also fixes up all
the sectional mismatches within the driver.
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/NCR_D700.c b/drivers/scsi/NCR_D700.c
index a06f547..d05681f 100644
--- a/drivers/scsi/NCR_D700.c
+++ b/drivers/scsi/NCR_D700.c
@@ -114,7 +114,7 @@
MODULE_LICENSE("GPL");
module_param(NCR_D700, charp, 0);
-static __u8 __initdata id_array[2*(MCA_MAX_SLOT_NR + 1)] =
+static __u8 __devinitdata id_array[2*(MCA_MAX_SLOT_NR + 1)] =
{ [0 ... 2*(MCA_MAX_SLOT_NR + 1)-1] = 7 };
#ifdef MODULE
@@ -173,7 +173,7 @@
char pad;
};
-static int
+static int __devinit
NCR_D700_probe_one(struct NCR_D700_private *p, int siop, int irq,
int slot, u32 region, int differential)
{
@@ -243,7 +243,7 @@
* essentially connectecd to the MCA bus independently, it is easier
* to set them up as two separate host adapters, rather than one
* adapter with two channels */
-static int
+static int __devinit
NCR_D700_probe(struct device *dev)
{
struct NCR_D700_private *p;
@@ -329,7 +329,7 @@
for (i = 0; i < 2; i++) {
int err;
- if ((err = NCR_D700_probe_one(p, i, slot, irq,
+ if ((err = NCR_D700_probe_one(p, i, irq, slot,
offset_addr + (0x80 * i),
differential)) != 0)
printk("D700: SIOP%d: probe failed, error = %d\n",
@@ -349,7 +349,7 @@
return 0;
}
-static void
+static void __devexit
NCR_D700_remove_one(struct Scsi_Host *host)
{
scsi_remove_host(host);
@@ -359,7 +359,7 @@
release_region(host->base, 64);
}
-static int
+static int __devexit
NCR_D700_remove(struct device *dev)
{
struct NCR_D700_private *p = dev_get_drvdata(dev);
@@ -380,7 +380,7 @@
.name = "NCR_D700",
.bus = &mca_bus_type,
.probe = NCR_D700_probe,
- .remove = NCR_D700_remove,
+ .remove = __devexit_p(NCR_D700_remove),
},
};