ncr5380: Remove duplicate comments
The LIMIT_TRANSFERSIZE, PSEUDO_DMA, PARITY and UNSAFE options are all
documented in the core drivers where they are used. The same goes for the
chip databook reference. Remove the duplicate comments.
Signed-off-by: Finn Thain <fthain@telegraphics.com.au>
Reviewed-by: Hannes Reinecke <hare@suse.de>
Signed-off-by: Christoph Hellwig <hch@lst.de>
diff --git a/drivers/scsi/dtc.c b/drivers/scsi/dtc.c
index 975abbf..43be785 100644
--- a/drivers/scsi/dtc.c
+++ b/drivers/scsi/dtc.c
@@ -19,24 +19,9 @@
* +1 (303) 440-4894
*
* DISTRIBUTION RELEASE 1.
- *
- * For more information, please consult
- *
- * NCR 5380 Family
- * SCSI Protocol Controller
- * Databook
-*/
+ */
/*
- * Options :
- * PSEUDO_DMA - enables PSEUDO-DMA hardware, should give a 3-4X performance
- * increase compared to polled I/O.
- *
- * PARITY - enable parity checking. Not supported.
- *
- * UNSAFE - leave interrupts enabled during pseudo-DMA transfers.
- * You probably want this.
- *
* The card is detected and initialized in one of several ways :
* 1. Autoprobe (default) - since the board is memory mapped,
* a BIOS signature is scanned for to locate the registers.