pinctrl: imx: accept gpio request/free from pinctrl
While only Freescale Vybrid SoC has settings of GPIO capabilities done
by iomux controller, it is only a matter of GPIO controller driver
implementation for the rest of Freescale/NXP SoCs from iMX series.
As a practical example on GPIO request a pad function should be
switched to GPIO, but because this requires updates to all particular
iMX pinctrl drivers, for simplicity at the moment add only a proper
connection between shared pinctrl-imx and pinctrl/pinmux core, namely
.gpio_request_enable/.gpio_disable_free/.gpio_set_direction callbacks
should return success to a caller. This change allows to progress by
adding request/free callbacks into gpio-mxc.c driver.
Signed-off-by: Vladimir Zapolskiy <vladimir_zapolskiy@mentor.com>
Acked-by: Shawn Guo <shawnguo@kernel.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>
diff --git a/drivers/pinctrl/freescale/pinctrl-imx.c b/drivers/pinctrl/freescale/pinctrl-imx.c
index 56fd880..4761320 100644
--- a/drivers/pinctrl/freescale/pinctrl-imx.c
+++ b/drivers/pinctrl/freescale/pinctrl-imx.c
@@ -315,7 +315,7 @@
/* Currently implementation only for shared mux/conf register */
if (!(info->flags & SHARE_MUX_CONF_REG))
- return -EINVAL;
+ return 0;
pin_reg = &info->pin_regs[offset];
if (pin_reg->mux_reg == -1)
@@ -380,7 +380,7 @@
* They are part of the shared mux/conf register.
*/
if (!(info->flags & SHARE_MUX_CONF_REG))
- return -EINVAL;
+ return 0;
pin_reg = &info->pin_regs[offset];
if (pin_reg->mux_reg == -1)