serial: mctrl_gpio: enable API usage only for initialized mctrl_gpios struct
This workaround is needed for the cases, where mctrl_gpio API is used
before mctrl_gpio_init() was invoked. This happens in 8250 during
console initialization, as the driver sets DTR signal.
Signed-off-by: Yegor Yefremov <yegorslists@googlemail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>
diff --git a/drivers/tty/serial/serial_mctrl_gpio.c b/drivers/tty/serial/serial_mctrl_gpio.c
index a868595..d2da6aa 100644
--- a/drivers/tty/serial/serial_mctrl_gpio.c
+++ b/drivers/tty/serial/serial_mctrl_gpio.c
@@ -52,6 +52,9 @@
int value_array[UART_GPIO_MAX];
unsigned int count = 0;
+ if (gpios == NULL)
+ return;
+
for (i = 0; i < UART_GPIO_MAX; i++)
if (gpios->gpio[i] && mctrl_gpios_desc[i].dir_out) {
desc_array[count] = gpios->gpio[i];
@@ -73,6 +76,9 @@
{
enum mctrl_gpio_idx i;
+ if (gpios == NULL)
+ return *mctrl;
+
for (i = 0; i < UART_GPIO_MAX; i++) {
if (gpios->gpio[i] && !mctrl_gpios_desc[i].dir_out) {
if (gpiod_get_value(gpios->gpio[i]))
@@ -91,6 +97,9 @@
{
enum mctrl_gpio_idx i;
+ if (gpios == NULL)
+ return *mctrl;
+
for (i = 0; i < UART_GPIO_MAX; i++) {
if (gpios->gpio[i] && mctrl_gpios_desc[i].dir_out) {
if (gpiod_get_value(gpios->gpio[i]))
@@ -221,6 +230,9 @@
{
enum mctrl_gpio_idx i;
+ if (gpios == NULL)
+ return;
+
for (i = 0; i < UART_GPIO_MAX; i++) {
if (gpios->irq[i])
devm_free_irq(gpios->port->dev, gpios->irq[i], gpios);
@@ -236,6 +248,9 @@
{
enum mctrl_gpio_idx i;
+ if (gpios == NULL)
+ return;
+
/* .enable_ms may be called multiple times */
if (gpios->mctrl_on)
return;
@@ -258,6 +273,9 @@
{
enum mctrl_gpio_idx i;
+ if (gpios == NULL)
+ return;
+
if (!gpios->mctrl_on)
return;