drm/i915: Replace DRM_DEBUG with DRM_DEBUG_DRIVER
Replace the DRM_DEBUG with DRM_DEBUG_DRIVER in generic i915 driver.
Then the debug info can be obtained by adding the boot option of
"drm.debug=0x02".
At the same time the debug info in increase/decrease clock is also
printed by using DRM_DEBUG_DRIVER instead of DRM_DEBUG_KMS.
Signed-off-by: Zhao Yakui <yakui.zhao@intel.com>
Signed-off-by: Eric Anholt <eric@anholt.net>
diff --git a/drivers/gpu/drm/i915/i915_dma.c b/drivers/gpu/drm/i915/i915_dma.c
index 138be49..6ade4a6 100644
--- a/drivers/gpu/drm/i915/i915_dma.c
+++ b/drivers/gpu/drm/i915/i915_dma.c
@@ -1073,7 +1073,7 @@
entry = *(volatile u32 *)(gtt + (gtt_addr / 1024));
- DRM_DEBUG("GTT addr: 0x%08lx, PTE: 0x%08lx\n", gtt_addr, entry);
+ DRM_DEBUG_DRIVER("GTT addr: 0x%08lx, PTE: 0x%08lx\n", gtt_addr, entry);
/* Mask out these reserved bits on this hardware. */
if (!IS_I9XX(dev) || IS_I915G(dev) || IS_I915GM(dev) ||
@@ -1099,7 +1099,7 @@
phys =(entry & PTE_ADDRESS_MASK) |
((uint64_t)(entry & PTE_ADDRESS_MASK_HIGH) << (32 - 4));
- DRM_DEBUG("GTT addr: 0x%08lx, phys addr: 0x%08lx\n", gtt_addr, phys);
+ DRM_DEBUG_DRIVER("GTT addr: 0x%08lx, phys addr: 0x%08lx\n", gtt_addr, phys);
return phys;
}