[S390] zcrypt: initialize ap_messages for cex3 exploitation
AP messages need to be initialized, before they will be used. Values
will be zeroized. This will be needed later when introducing support
for the special commands.
Signed-off-by: Felix Beck <felix.beck@de.ibm.com>
Signed-off-by: Ralph Wuerthner <ralph.wuerthner@de.ibm.com>
Signed-off-by: Martin Schwidefsky <schwidefsky@de.ibm.com>
diff --git a/drivers/s390/crypto/ap_bus.h b/drivers/s390/crypto/ap_bus.h
index a353622..fcf2497 100644
--- a/drivers/s390/crypto/ap_bus.h
+++ b/drivers/s390/crypto/ap_bus.h
@@ -167,6 +167,17 @@
.dev_type=(dt), \
.match_flags=AP_DEVICE_ID_MATCH_DEVICE_TYPE,
+/**
+ * ap_init_message() - Initialize ap_message.
+ * Initialize a message before using. Otherwise this might result in
+ * unexpected behaviour.
+ */
+static inline void ap_init_message(struct ap_message *ap_msg)
+{
+ ap_msg->psmid = 0;
+ ap_msg->length = 0;
+}
+
/*
* Note: don't use ap_send/ap_recv after using ap_queue_message
* for the first time. Otherwise the ap message queue will get