[SCSI] tmscsim: remove bogus endianness conversions
cpu_to_le32 endianness conversions in tmscsim.c, followed by
arithmetic operations don't look correct. Besides, {in,out}[wl]
already perform the necessary conversions. Further, bus addresses
of request buffers are guaranteed to be (mapped) under 4G by
current scsi- and block-layer defaults. This could be explicitly
enforced by using blk_queue_bounce_limit(), which, however,
doesn't seem to be the common practice among SCSI drivers.
Signed-off-by: G. Liakhovetski <g.liakhovetski@gmx.de>
Signed-off-by: James Bottomley <James.Bottomley@SteelEye.com>
diff --git a/drivers/scsi/tmscsim.c b/drivers/scsi/tmscsim.c
index bc0a007..12d8fea 100644
--- a/drivers/scsi/tmscsim.c
+++ b/drivers/scsi/tmscsim.c
@@ -778,8 +778,8 @@
pSRB->pSegmentList++;
psgl = pSRB->pSegmentList;
- pSRB->SGBusAddr = cpu_to_le32(pci_dma_lo32(sg_dma_address(psgl)));
- pSRB->SGToBeXferLen = cpu_to_le32(sg_dma_len(psgl));
+ pSRB->SGBusAddr = sg_dma_address(psgl);
+ pSRB->SGToBeXferLen = sg_dma_len(psgl);
}
else
pSRB->SGToBeXferLen = 0;
@@ -842,7 +842,7 @@
DEBUG1(ResidCnt = ((unsigned long) DC390_read8 (CtcReg_High) << 16) \
+ ((unsigned long) DC390_read8 (CtcReg_Mid) << 8) \
+ ((unsigned long) DC390_read8 (CtcReg_Low)));
- DEBUG1(printk (KERN_DEBUG "Count_2_Zero (ResidCnt=%i,ToBeXfer=%li),", ResidCnt, pSRB->SGToBeXferLen));
+ DEBUG1(printk (KERN_DEBUG "Count_2_Zero (ResidCnt=%u,ToBeXfer=%lu),", ResidCnt, pSRB->SGToBeXferLen));
DC390_write8 (DMA_Cmd, READ_DIRECTION+DMA_IDLE_CMD);
@@ -853,8 +853,8 @@
pSRB->pSegmentList++;
psgl = pSRB->pSegmentList;
- pSRB->SGBusAddr = cpu_to_le32(pci_dma_lo32(sg_dma_address(psgl)));
- pSRB->SGToBeXferLen = cpu_to_le32(sg_dma_len(psgl));
+ pSRB->SGBusAddr = sg_dma_address(psgl);
+ pSRB->SGToBeXferLen = sg_dma_len(psgl);
}
else
pSRB->SGToBeXferLen = 0;
@@ -921,11 +921,12 @@
ptr = (u8 *) bus_to_virt( pSRB->SGBusAddr );
*ptr = bval;
- pSRB->SGBusAddr++; xferCnt++;
+ pSRB->SGBusAddr++;
+ xferCnt++;
pSRB->TotalXferredLen++;
pSRB->SGToBeXferLen--;
}
- DEBUG1(printk (KERN_DEBUG "Xfered: %li, Total: %li, Remaining: %li\n", xferCnt,\
+ DEBUG1(printk (KERN_DEBUG "Xfered: %lu, Total: %lu, Remaining: %lu\n", xferCnt,\
pSRB->TotalXferredLen, pSRB->SGToBeXferLen));
}
@@ -1157,14 +1158,14 @@
{
pSRB->pSegmentList++;
psgl = pSRB->pSegmentList;
- pSRB->SGBusAddr = cpu_to_le32(pci_dma_lo32(sg_dma_address(psgl)));
- pSRB->SGToBeXferLen = cpu_to_le32(sg_dma_len(psgl));
+ pSRB->SGBusAddr = sg_dma_address(psgl);
+ pSRB->SGToBeXferLen = sg_dma_len(psgl);
}
else
pSRB->SGToBeXferLen = 0;
}
- pSRB->SGToBeXferLen -= (pSRB->Saved_Ptr - pSRB->TotalXferredLen);
- pSRB->SGBusAddr += (pSRB->Saved_Ptr - pSRB->TotalXferredLen);
+ pSRB->SGToBeXferLen -= pSRB->Saved_Ptr - pSRB->TotalXferredLen;
+ pSRB->SGBusAddr += pSRB->Saved_Ptr - pSRB->TotalXferredLen;
printk (KERN_INFO "DC390: Pointer restored. Segment %i, Total %li, Bus %08lx\n",
pSRB->SGIndex, pSRB->Saved_Ptr, pSRB->SGBusAddr);
@@ -1315,8 +1316,8 @@
if( !pSRB->SGToBeXferLen )
{
psgl = pSRB->pSegmentList;
- pSRB->SGBusAddr = cpu_to_le32(pci_dma_lo32(sg_dma_address(psgl)));
- pSRB->SGToBeXferLen = cpu_to_le32(sg_dma_len(psgl));
+ pSRB->SGBusAddr = sg_dma_address(psgl);
+ pSRB->SGToBeXferLen = sg_dma_len(psgl);
DEBUG1(printk (KERN_DEBUG " DC390: Next SG segment."));
}
lval = pSRB->SGToBeXferLen;
diff --git a/drivers/scsi/tmscsim.h b/drivers/scsi/tmscsim.h
index 9b66fa8..c3d8c80 100644
--- a/drivers/scsi/tmscsim.h
+++ b/drivers/scsi/tmscsim.h
@@ -19,14 +19,6 @@
#define SEL_TIMEOUT 153 /* 250 ms selection timeout (@ 40 MHz) */
-#define pci_dma_lo32(a) (a & 0xffffffff)
-
-typedef u8 UCHAR; /* 8 bits */
-typedef u16 USHORT; /* 16 bits */
-typedef u32 UINT; /* 32 bits */
-typedef unsigned long ULONG; /* 32/64 bits */
-
-
/*
;-----------------------------------------------------------------------
; SCSI Request Block
@@ -43,7 +35,9 @@
struct scatterlist Segmentx; /* make a one entry of S/G list table */
-unsigned long SGBusAddr; /*;a segment starting address as seen by AM53C974A*/
+unsigned long SGBusAddr; /*;a segment starting address as seen by AM53C974A
+ in CPU endianness. We're only getting 32-bit bus
+ addresses by default */
unsigned long SGToBeXferLen; /*; to be xfer length */
unsigned long TotalXferredLen;
unsigned long SavedTotXLen;