ALSA: via82xx_modem: Use standard printk helpers
Convert with dev_err() and co from snd_printk(), etc.
Signed-off-by: Takashi Iwai <tiwai@suse.de>
diff --git a/sound/pci/via82xx_modem.c b/sound/pci/via82xx_modem.c
index 5197401..46a0526 100644
--- a/sound/pci/via82xx_modem.c
+++ b/sound/pci/via82xx_modem.c
@@ -312,7 +312,7 @@
unsigned int addr;
if (idx >= VIA_TABLE_SIZE) {
- snd_printk(KERN_ERR "via82xx: too much table size!\n");
+ dev_err(&pci->dev, "too much table size!\n");
return -EINVAL;
}
addr = snd_pcm_sgbuf_get_addr(substream, ofs);
@@ -329,8 +329,9 @@
} else
flag = 0; /* period continues to the next */
/*
- printk(KERN_DEBUG "via: tbl %d: at %d size %d "
- "(rest %d)\n", idx, ofs, r, rest);
+ dev_dbg(&pci->dev,
+ "tbl %d: at %d size %d (rest %d)\n",
+ idx, ofs, r, rest);
*/
((u32 *)dev->table.area)[(idx<<1) + 1] = cpu_to_le32(r | flag);
dev->idx_table[idx].offset = ofs;
@@ -382,7 +383,7 @@
if (!((val = snd_via82xx_codec_xread(chip)) & VIA_REG_AC97_BUSY))
return val & 0xffff;
}
- snd_printk(KERN_ERR "codec_ready: codec %i is not ready [0x%x]\n",
+ dev_err(chip->card->dev, "codec_ready: codec %i is not ready [0x%x]\n",
secondary, snd_via82xx_codec_xread(chip));
return -EIO;
}
@@ -443,7 +444,8 @@
xval |= (reg & 0x7f) << VIA_REG_AC97_CMD_SHIFT;
while (1) {
if (again++ > 3) {
- snd_printk(KERN_ERR "codec_read: codec %i is not valid [0x%x]\n",
+ dev_err(chip->card->dev,
+ "codec_read: codec %i is not valid [0x%x]\n",
ac97->num, snd_via82xx_codec_xread(chip));
return 0xffff;
}
@@ -560,7 +562,9 @@
((pos) < viadev->lastpos && ((pos) >= viadev->bufsize2 ||\
viadev->lastpos < viadev->bufsize2))
-static inline unsigned int calc_linear_pos(struct viadev *viadev, unsigned int idx,
+static inline unsigned int calc_linear_pos(struct via82xx_modem *chip,
+ struct viadev *viadev,
+ unsigned int idx,
unsigned int count)
{
unsigned int size, res;
@@ -570,20 +574,21 @@
/* check the validity of the calculated position */
if (size < count) {
- snd_printd(KERN_ERR "invalid via82xx_cur_ptr (size = %d, count = %d)\n",
+ dev_err(chip->card->dev,
+ "invalid via82xx_cur_ptr (size = %d, count = %d)\n",
(int)size, (int)count);
res = viadev->lastpos;
} else if (check_invalid_pos(viadev, res)) {
#ifdef POINTER_DEBUG
- printk(KERN_DEBUG "fail: idx = %i/%i, lastpos = 0x%x, "
- "bufsize2 = 0x%x, offsize = 0x%x, size = 0x%x, "
- "count = 0x%x\n", idx, viadev->tbl_entries, viadev->lastpos,
+ dev_dbg(chip->card->dev,
+ "fail: idx = %i/%i, lastpos = 0x%x, bufsize2 = 0x%x, offsize = 0x%x, size = 0x%x, count = 0x%x\n",
+ idx, viadev->tbl_entries, viadev->lastpos,
viadev->bufsize2, viadev->idx_table[idx].offset,
viadev->idx_table[idx].size, count);
#endif
if (count && size < count) {
- snd_printd(KERN_ERR "invalid via82xx_cur_ptr, "
- "using last valid pointer\n");
+ dev_dbg(chip->card->dev,
+ "invalid via82xx_cur_ptr, using last valid pointer\n");
res = viadev->lastpos;
} else {
if (! count)
@@ -595,8 +600,8 @@
*/
res = viadev->idx_table[idx].offset + size;
if (check_invalid_pos(viadev, res)) {
- snd_printd(KERN_ERR "invalid via82xx_cur_ptr (2), "
- "using last valid pointer\n");
+ dev_dbg(chip->card->dev,
+ "invalid via82xx_cur_ptr (2), using last valid pointer\n");
res = viadev->lastpos;
}
}
@@ -632,7 +637,7 @@
else /* CURR_PTR holds the address + 8 */
idx = ((ptr - (unsigned int)viadev->table.addr) / 8 - 1) %
viadev->tbl_entries;
- res = calc_linear_pos(viadev, idx, count);
+ res = calc_linear_pos(chip, viadev, idx, count);
spin_unlock(&chip->reg_lock);
return bytes_to_frames(substream->runtime, res);
@@ -991,7 +996,8 @@
} while (time_before(jiffies, end_time));
if ((val = snd_via82xx_codec_xread(chip)) & VIA_REG_AC97_BUSY)
- snd_printk(KERN_ERR "AC'97 codec is not ready [0x%x]\n", val);
+ dev_err(chip->card->dev,
+ "AC'97 codec is not ready [0x%x]\n", val);
snd_via82xx_codec_xwrite(chip, VIA_REG_AC97_READ |
VIA_REG_AC97_SECONDARY_VALID |
@@ -1054,8 +1060,7 @@
pci_set_power_state(pci, PCI_D0);
pci_restore_state(pci);
if (pci_enable_device(pci) < 0) {
- printk(KERN_ERR "via82xx-modem: pci_enable_device failed, "
- "disabling device\n");
+ dev_err(dev, "pci_enable_device failed, disabling device\n");
snd_card_disconnect(card);
return -EIO;
}
@@ -1137,7 +1142,7 @@
chip->port = pci_resource_start(pci, 0);
if (request_irq(pci->irq, snd_via82xx_interrupt, IRQF_SHARED,
KBUILD_MODNAME, chip)) {
- snd_printk(KERN_ERR "unable to grab IRQ %d\n", pci->irq);
+ dev_err(card->dev, "unable to grab IRQ %d\n", pci->irq);
snd_via82xx_free(chip);
return -EBUSY;
}
@@ -1186,7 +1191,7 @@
sprintf(card->shortname, "VIA 82XX modem");
break;
default:
- snd_printk(KERN_ERR "invalid card type %d\n", card_type);
+ dev_err(card->dev, "invalid card type %d\n", card_type);
err = -EINVAL;
goto __error;
}