wil6210: capture all frames in sniffer mode
For the sniffer (monitor) mode, capture either control only or both
control and data PHY.
It used to be control only or data only PHY due to firmware
issues with configuration for PHY auto-detection; but now
it is resolved.
Signed-off-by: Vladimir Kondratiev <qca_vkondrat@qca.qualcomm.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>
diff --git a/drivers/net/wireless/ath/wil6210/wmi.c b/drivers/net/wireless/ath/wil6210/wmi.c
index 2f35d4c..6112189 100644
--- a/drivers/net/wireless/ath/wil6210/wmi.c
+++ b/drivers/net/wireless/ath/wil6210/wmi.c
@@ -1120,7 +1120,7 @@
cpu_to_le32(ndev->type == ARPHRD_IEEE80211_RADIOTAP);
cmd.sniffer_cfg.phy_support =
cpu_to_le32((wil->monitor_flags & MONITOR_FLAG_CONTROL)
- ? WMI_SNIFFER_CP : WMI_SNIFFER_DP);
+ ? WMI_SNIFFER_CP : WMI_SNIFFER_BOTH_PHYS);
} else {
/* Initialize offload (in non-sniffer mode).
* Linux IP stack always calculates IP checksum